Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I don't understand how the Meraki MS routing feature set doesn't include the IP SLA capability. It severely hampers the ability to do failover from one firewall to another in two separate sites. Basically, we have two main sites, each ...
Cisco Support Forums,
We are switching out a firewall that has SIP ALG to a Meraki firewall that doesn't do SIP ALG. There is a Cisco 4321 that is running as a CUBE, it has a private IP interface that is NAT'd from the outside, so now without SIP...
Hello All,
I have a client who is using the Unity Connection Notification Device for phone. This is where Unity Connection places an outbound call to the cell phone. Unity Connection is a cluster integrated into CUCM with two SIP trunks. They a...
Hello All,
I have a question of the effect of the device mobility feature in CUCM. When a device is roaming, it still has access to the CSS's configured on the lines of the phone? The only CSS that changes dynamically is the phones CSS correct? ...
Hello All,
I'am having an issue with a CME router that is on version 11.6 and adding two 8811 phones to the configuration. Auto registration was previously enabled. I was able to get the phone to auto register successfully. However when we di...
CMR, MX's as I was told don't by Meraki support, does not run OSPF on the inside interface. It only is used for routing across VPN to other MX's. It's just another case of Cisco limiting the feature set. It's frustrating.
Roger,
I appreciate it! The working phone is pool 6 below, its no different then the non working phone which is pool 16. It does however look like it was previously configured for auto registration since it has the password and username in there...
