Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have replaced my old SG300-10P with a new CBS350-8P-E-2G but having some problem with PoE and a IP phone. When I reboot the switch it works for few hours and then the phone is off, i.e. has no power. I have only two PoE devices connected, an access...
I wanted to update a WLC 2504 to the new version 8.5.103.0 using download file AIR-CT2500-K9-8-5-103-0.aes.
However, when I tried to predownload the version to the access points (two 1602I and one 1702I) only the 1702I loaded the new version. For th...
I have upgraded a 2504 controller to 8.0.110.0. Since then I see this error message every two minutes:
wlc: *spamApTask7: Feb 17 12:07:23.854: #CAPWAP-3-DISC_AP_MGR_ERR1: capwap_ac_sm.c:2008 The system is unable to process Primary discovery request...
Hi!I am trying to setup my 1812 with 15.1(4)M to do 6to4 tunneling through the anycast address 192.88.99.1 but can't get it working.Config extract:ipv6 general-prefix my-prefix 6to4 FastEthernet0ipv6 unicast-routingipv6 cef!interface Tunnel0 no ip ad...
@d0nni3q84 wrote:Did you ever find a solution? I am facing the same issue on a CBS350-24P-4G and CBS350-8P-E-2G running 3.1.1.7 and floored that the switch is trying to perform POE operations ports that are clearly disabled.After a couple of more tes...
Global IPv6 config is enabled as I need IPv6 and as far as I understand clients won't be able to use IPv6 otherwise.I haven't found a way to disable IPv6 for discovery... Gerald
