Network Security

I was wondering if anybody had managed to get VMWare VDI working though a WebVPN session? Is this doable or should I stop looking?

I'm having issues when I point my clients DHCP lease gatway to the inside addr of the ASA ( they can not connect to any internal network the ASA has routes too. I validated from the ASA inside addr can see these networks "ping" and he recieves repli...

I have two 6500 core switches in failover (HSRP) config. Both switches have IDSM-2 modules.I have about 5 VLANs to monitor using IDSM in-line. Since IDSM has two interfaces to monitor trafic, I have to create 8 VLANs and do VLAN pairing in order to m...

Hello,I'm wondering if somebody is using the filters to get get rid of the logging for the antivirus updates. Usually the antivirus updates cause the signature 2100 to fire. IPS configuration guide says:When filtering sweep signatures we recommend, t...

Wanted to know how many individual session can a VPN Tunnel support?The reason I am asking this is I have a L2L between my VPN 3030 concentrator and a Vendors ASA5540, there are 30 Sessions going over the tunnel at any one time, I am having issues ...

Hi All, I have setup IEV to create archive file every night at 12:00, and it creates archive file without any problem. But my question is how I can view those archive file. I'd like to view archive file with IEV not by CSV file which is hard to read....

(inside network) one switch+ Router+firewall+router+Switch(outside network) outside network have total four users inside one printer all four users have to access the one printer with single ip address out side starting with 10.1.1.110.1.1.2,10.1.1.3...

I have ASA 5505 with ASA v 803 is re- ordering the packets ,When we access the webserver and enter username and password after that it send us reset that is packet re-ordering , I am lloking for the solution that stop pakcets re-ordering on the AS...

hey all, we have a customer failing the spank.c security scan. there is no multicast enabled on the outside. anyone else have any luck with this?http://www.securityspace.com/smysecure/catid.html?id=11901

Looking for a command line tool that can show which IP is utilizing most of the bandwidthI have PRTG running and monitoring the outside interface. When it spikes to 15 Mbps and sustains for over 10 minutes I get an email. Next step is trying to narro...

our IPS is not updating automatically, not sure what could be the problem.Any idea.

Hi,we're running two FWSMs in two seperate 6500s. When a failover test occurs (triggered by "failover active" on the cli on the primary FWSM), the 6500s don't notice that circumstance, although all snmp traps are activated there. This seems to be as ...

Hello,I pass default traffic from inside to outside interface. Also I have to pass inside traffic back to inside interface to get some servers. I have configured default route to outside and a route to this servers subnet to inside. route outside 0.0...