Network Security

Hi,I would like to know if IPM ( ciscoWorks) supports the scheduling of probes.For example:ip sla monitor schedule 1 life 300 start-time after 00:05:00ThanksrgdsAbdelBskyB Uk

Hi,I've purchased a 16MB ISA Flash Card for a PIX520 to operate in a QA environment. Reading the instructions, it states that it comes with Pix 5.2 preloaded. I've removed the old 2MB card and installed the 16MB but when I boot the PIX I get the usua...

Hi Everbody My ASA 5510 with the CSC module has a Problem with FTP download. I use normaly FTP Protocoll to download files. The Problem is, it intercept the Filedownload after a certain time. It look like a timeout. the download goes from the Interne...

Hello:I am having problem with the CCAAgent download page. When users access resources on the network, for the first time, they are directed to the Weblogin page without an option to download the CCAAgent. My environment is OOB virtual gateway with H...

Hi - I am new to Cisco NetPro forum,I have a dilemma/question relating to bridging two networks utilising an ASA 5505 device.We are in the process of connecting two MPLS networks with a 4Mbps link, for example:MPLS 1 Network address is 172.100.0.0/24...

Hi all,I have seen this a lot with routers and PIXs. Traffic with a source port of port 80 and destination of a dynamic port is denied on the outside interface.The traffic is from legitimate web servers that users are browsing through the NATed inspe...

I have a Cisco 5510 that has a DMZ setup on it and supports Remote Access via the legacy client, not web or SSL. While on VPN I can get to all internal resources, have no problems. However I cannot conect to any resouce in the Dmz. I've look at the N...

Hi,I was reading CSCse92254 Bug Details and it says that ASA OS version 8.3 is released. I quote part of the bug detail as follows "- IKEv2 is a much better solution and will be implemented both on the AnyConnect Client and on the ASA. Dates have not...

Hello,I am reading through the ASA 8.x release notes for a potential upgrade. Currently, a device is running OS 7.22 and ASDM 5.22. It has 256DRAM and 128 MB flash. I think the confusing area is the amount of flash I need. I keep reading I need to ge...

Dears,As we know in Routers, we create a local Username/password and configure the vty line with "privilege level 15" command and the user will go directly to priv mode.how can we do this in ASA/FWSM??? I have done AAA and also Local U&P, the users g...

hi there,ive recently set up the CSC SSM module on an ASA5510 and when i try to the updates from Trend Micro, it says it cant connect. can someone explain how you would set the management network (192.168.11.0/24) to access the Internet?Regards

Hi,We are using PIX 515E Firewall and right now we are planning for the redunancy in our firewall so can any one help me how i can deploy the new Firewall for redunancyAnd also procedure for deploying redunancy on the FirewallRegards,Vinu