Network Security

I work for a video conferencing company and we are looking to get a new firewall as our current Adtran firewall has some issues with a certain codec.We are a small company that is trying to keep it cheap but I also don't want to waste time on somethi...

I am working at a customer site where he has an ASA deployed between the Internet and the Inside networks.I was examining the logs on the appliance today, and found this message repeating. I am curious if this is being caused by the following comman...

What is the way to get the arp table on an ASA using snmp? I tried doing an snmp walk on .1.3.6.1.2.1.4.22, which works on a Cisco router, but got nothing.ThanksMike

I have a customer whose IT guy left, and I am trying to gain access to their PIX 501 F/W via the http web interface. I do have telnet/enable access to the device, but I seem to be unable to re-enable the http interface from the telnet command line. ...

I have a PIX 501 that I am setting up at a site that has one static ip address and a router. I have never setup a PIX 501 without a public address on the WAN so this is new to me. I have assigned the outside interface of the pix to 192.168.0.254. ...

I have a IDS-4215 sensor with version 5.1(5)E1S333V1.2I tried several times updating signatures with next version on it but it doesnot get updated and only the local MC gets upgraded. I have other IDS sensors also but I dont have any problem updating...

Can anyone tell me what causes the errors and drops to increment on a show logging output? See below:Syslog logging: enabled Facility: 17 Timestamp logging: enabled Standby logging: enabled Deny Conn when Queue Full: disabled Console ...

I'm not after the command to do this.My question is, I would obviously NAT addresses going through the external interface. However, what are the reasons for/against NATing addresses between the DMZ and Internal network ?If you had :DMZ 192.168.1.0 / ...

I have an issue with ASA 5510 Firewall.I have three interfaces X,Y and Z, where X has a security level of 0, Y=0 and Z=10.I need to access hosts on Y from Z.As of now it works fine with NAT.All i want is to access hosts with no NATing.I have applied ...

Please suggest any free tool which can automatically analyse the logs from the firewall, collected in kiwi syslog server.reagrds, Naveen.

Hi,I have an issue were there is no phase 2 being negotiated for a specific subnet. I have checked that the policys match on the ipsec config which they do and timers etc. Everything looks ok but the router refuses to encrypt any traffic even thoug...

I have 7.2 (2) on my ASA.. I want to get same sort of dashboard as it is there on ASDM Demo (6.0), like Top 10 Access Rules, Traffic overview, Top Usage Status, etc.. how can i get that in my real ASA?

This is what I currently have:access-list incoming permit tcp any host 2.3.245.131 eq wwwaccess-list incoming permit tcp any host 2.3.245.131 eq httpsip address outside 2.3.245.134 255.255.255.192static (inside,outside) 2.3.245.131 192.168.1.10 netma...