Network Security

NAC Network session never begins so client posture is not checkedExtract from logs on a working clientCTA Posture State service started7 23:36:53.218 07/04/2008 Sev=Info/4 CTASTATE/0x64400001Value written to the registry8 23:52:43.093 07/04...

Hi!I want to clear a connection in my ASA but I have found that "clear conn" command doesn't work with ASA falover.How can I clear a connection with this configuration?Thank youAlex

Hi, I have recently setup a remote VPN over ASA and its working fine. Now as per security concerned I want that client could able to use VPN connection by only their Laptops from outside Nework if they try to use like cyber cafe machines then It coul...

Hi,I am trying to put forward a NAC solution for our <very> small office - around 30 users. I think NAC's a great solution to enforce a tight security policy, and I want to ensure users connecting to our Data Centre have been properly (de)wormed I am...

Dear allplease advice me, how to resetting password in ASA5520-AIP-SSM-20.Note:according to cisco PDF, i carried out, but still required username/password.Pls. let me know what is the default username/password for AIP-SSM-20Thanks & regards

Dear all,I've been trying to configure a Cisco ASA 5505 to connect to a remote VPN. Once connected all traffic should then present itself from one IP over the VPN using NAT. I have two VLANs called inside and outside. The inside IP is 192.168.20.0...

I was wondering if there is something in the VPN Mibs ( or elsewhere ) that will let me figure out if a particular device is acting as a HUB, spoke or full mesh device for a given VPN. I tried using the Route target type - Import/Export/both, but it...

We are eliminating split-tunnel VPN's for remote user access for security reasons. However, many of our users require access to a couple of business-related websites from VPN. We have an ASA 5520 running ASDM 6.0 and looking at the tab for split-tu...

Hi folks, I'm fairly new to this, but in doing configuring/testing of 5510s, I have an issue with just one unit. I'm bringing the SCL up to level 5 from either 0 or 2, then doing a config. for our customer, then running a test on all the connectivity...

I have a DR site, I already have both firewalls not being used, the 515E and the Fortinet 60...Any thoughts on which I should use? We only have 1 ISP at our DR site with a T1...

Hi, Recently I have started work on ASA and now I want to make backup Server and Syslog Server. Can anyone send a document. Is there anything else which i should make it for disaster recovery. Thanks

Hi,We have configured remote access VPN in our ASA5540. (ASA Ver. 7.2(2). We have 3 VPN groups setups. Sometime any users belongs to any of these groups diconnect after 05-06 seconds once they connected. Once I re-start the ASA all users are able sta...

I'm trying to get a tunnel up and running between an ASA 5510 and a Cisco 1812.On the ASA, whith debug turned on, i get the following: "... No crypto map bound to interface... dropping pkt"any hints?ct,

Hello'sI'm in the market looking to replace my current PIX firewalls. I've been looking at the ASA and the competition (Checkpoint, SonicWall) and was wondering if i could get some added expert opinion on how you think the ASA compares/competes.thank...