Network Security

I am having issues with an ASA 5505 not timing out after setting the vpn-idle-session time-out command. I tried setting the value to 2 minutes, but the connection remains intact. I need it so that the session to timeout after 30 min of no user activi...

does the CSA 6.0 released or not yetbecause it was supposed to be released at may 2008 is there .msi package available for CSA

Is there a way to block activex and java using the ASA? I would need to block all activex/java with the exception of a few requested sites, is that possible?

Hi,My Firewall PIX 501 doesn't stop rebooting in loop. I can't access to the running configuration just in rom monitor.Please find attached the log. An internal error occurred. Specifically, a rrogramming assertion wasviolated. Copy the error message...

Hi all,im getting a problem mapping address on ASA.I have a outside host (host-A) (10.10.10.2) on same switch that outside ASA interface (10.10.10.1) is plugged. And I have another host (host-B) on DMZ (172.16.2.2). I wanna map the outside address 10...

I'm using a PIX 515E with version 7.0, connected on the outside to the Internet, and on the inside to a router, both with IPs in the 192.168.3.0/24 subnet. "Behind" the router is a 192.168.1.0/24 subnet. I want to configure static NAT entries on the ...

Hi,I've recently installed two 2801 routers and tried to get VRRP working with my EasyVPN server. However this keeps on failing I can connect using the Cisco VPN client to either of the two routers, but as soon as I enable VRRP and connect to the VRR...

Receiving the following log while attempting to ssh to ASA 8.0.3.Resource 'ssh' limit of 5 reached for context 'single_vf'I have tried regenerating the rsa key."show resource usage resource ssh" displays Resource - SSH Current - 5Peak - 5Limit - 5Den...

I am trying to setup a VPN on this ASA using AnyConnect. I was able to get the IPSec VPN to work but we have to use AnyConnect for Vista support. I have the VPN part working to where clients can establish a VPN connection. The problem is that they ca...

Hi,I can get SNMP info from all of the interfaces on my ASA except the "Outside" interface. It's been working fine for months until a couple of hours ago, what can I do?Thanks

Hello Guys, We have established VPN connection between my office/ATL and Remote office in India. We are exchanging packets between both private networks. India has DMZ server with public IP address that could not communicate with my private network. ...

Anyone else notice that the latest in the 7.2 ASA code train changed the functionality of one of the most basic of commands. This change was also not documented in the release notes. We went to this release due to the last round of security issues. T...

In a active/standby config, should I use a hardwired cross-connection between them or a separate switch between them. How about in a active/active config? Thanks