Network Security

Hi,In my office one new IBM AS/400 server is installed.The server internal ip is nated with public ip and opened 6013 port.The server applications are fast through local LAN but it's dead slow when it is accessing through internet by the outside user...

I have an active/standby ASA in my network. I would like them both to be monitored by hp openview. Right now only the active ASA can be viewed by HP openview and there is ip connectivity to both. Are there any special steps that must be taken in o...

Just a quick question if you are using a group of ironports as web proxies which wccp service number do they use?Sorry if this is a dumb question but I am trying to learn how to connect them up and can not find this anywhere through google.

I do not know the password nor do I know the inside IP address (which means that I cannot perform the np63.bin upload). Any suggestions - just need to get back to factory default.

Dear All,I installed ASA5520 pair in transparent mode for the server farm in one of my customer data center. The server farm switches are 3750 with stacked using the stacking cable.When i found the primary firewall in standby i used in console "failo...

Hi all,I want to config VPN Failover on ASA 5520. My ASA behind an Load balancer which has two public IP addresses. Please guide me with this scenario.Thanks & Best Regards!

I am trying setup up remote access to be able to support PIX and ASA units I have vpn working but I am not sure how to configure the remote access and PDM

When you SSH into an ASA, how do you change the default username of "pix"? In other words, the passwd command changes the password, but how do you change the username?

We are running a PIX 501 (6.3)We have it set up as a firewall/vpn router on a DSL modem.We have several computer on the inside interface, IP range 192.168.1.0The PIX is set to give out DHCP address from 192.168.1.2 to .33If the PIXs gives a computer ...

hi I have following fw routing issue on pix 7 fwroute int2 x.x.x.5 255.255.255.255 gtw2 1route int1 x.x.x.0 255.255.128.0 gtw1 2I want traffic to x.x.x.5 goes over int2, but no metter what I do, traffic goes over int1. How to solve this?

Hi,Does anyone now a tool that permits me to export a pix 7.x configuration to an HTML page ?Thanks and best regards,Bruno Fernandes

I have a Cisco 5510 ASA firewall IOS Version is 8.0.3The ASDM version is 6.0.3. This firewall will replace a Ciso Pix 506.I have notice that when I use the command [ tunnel-group JBoy type ipsec-ra]it gets changed to [ tunnel-group JBoy type remote-a...

hi,the asa 5500 has 2 webvpn-licenses included. will i have 12 licenses when i add a 10 user-license?thanks

Hi,We use Altiris between two VPN sites protected by a Cisco PIX (8.0) and an ASA (8.0).Altiris communicates some multicast traffic on tcp port 402, but this traffic get blocked by the firewalls with this message:%pix-6-106015: deny tcp (no connectio...

Hi everybody,I have a web server inside the firewall and I need to publish two IP addresses to access this web server, but I need to have one IP address internally. I can this using Extendable NATs in Cisco Routers, but I couldnt find a way to do it ...