Network Security

Hi, ASA FW is configured for our branch office and Access to our servers seems to have slowed down significantly from outside network. Can anyone send us intructions what should be do to resolve this issue .Thanks.

Hi, Can we assign bandwidth a particular machine/device/server. I have 1 mbps lease line can i allocate 256*2 for two servers and rest bandwidth by default assign (512) to local network users.

Is FWSM supported with VSS1440 on the Cisco 6500 series switch?

Hi..I'm trying to install a NAC profiler 2.17 - but it will not install the license.I have tried to upload through IE and Firewall. It just says : License was successfully uploaded.But if I try to start the /etc/init.d/profiler it starts for a few se...

I have a customer, due to cost saving, recently migrated froma checkpoint NGx firewall over to Cisco ASA 5510 firewall with 8.0(3).There is a Linux host on the internal network that supports snmp version 1, 2c and 3. I want host Linux_internal to que...

If all users are located behind a proxy, what user (proxy ip) or users (all users) are counted as license over CSC-SSM ? Thanks.

Hello,I have 2 ASA 5510 SEC-BUNI want to enable failover.I have this configuration : Ethernet 0/0 : OutsideEthernet 0/1 : InsideEthernet 0/2 : DMZI follow the example : How to configure Failover on ASA, and i can read that i need two interface :One f...

Hi,I try to give an access to an intranet app through VPN SSL portal. I get an error when clicking on a menu which use a text based parameter. The box seems to add a quote which disturb the app.Anyone can help me ?

we currently have several offices internationally. Each Office is considered an untrusted site, so we have firewalls between offices. Most of these firewalls started with Pix 6.3 but have been upgraded to 7.2. Many of the rules have been put in place...

Below is the description for the message ID 106100,"If you configured the log option for the access-list command, the packets matched an ACL statement. The message level depends on the level set in the access-list command (by default, the level is 6)...

I have a MSFC -> FWSM(A/S FO) -> ACE(FO) design using 2 security contexts, with the ACE modules in bridged mode. I notice the servers on the server side VLAN(501) on the ACE module sometimes show up on the client side VLAN(500), when I do a show arp ...

I want to exclude some of my network's internal IP addresses as sources. This is a recommended action for some signatures fired on the AIP-SSM of my ASA.Pls, how and from which of the devices do I exclude the IP addresses.

I'm sure there is something easy I'm missing, but I'm missing it. I have a lan-to-lan VPN established between a VPN Concentrator 3030 and an ASA something or other on the other side. I don't own the device on the other side. Because of an IP conflict...