Network Security

What is the most memory I can add to this device in its current restricted bundle config? Currently has 64mb in one slot.

I am using PIX 6.3, and want to setup a Remote VPN for my windows users. I use the below configuration, but it doesn't work. can someone tell me what configure I miss?==========================================vpdn group test accept dialin l2tpvpdn gr...

Hi Guys,Attached is screenshot when I access the web interface by admin/cisco123 after initial setup for CAM. It not showing all the configuration part except monitoring page.Did I miss something , thanks in advance.

Does anyone know how to do this or when this will be supported? I have a bunch of remote LANs with the same subnet.

Hi all,I am trying to run the ASDM on a Windows XP machine but I am getting the following error:"Unable to lauch ASDM from 170.55.27.140No trusted certificate found"I cannot figured out what's wrong here, have anyone seen this error before?regards

Hi all, I need some help regarding a deployment of a IPS module on a ASA. I configured it in transparent mode, with the intention to only monitor the traffic going through the module. Otherwise after aplying the policy and put it in operation, it sta...

Hi,On PIX, how to difine ACL to allow a big range of subnets in which the third part of IP is same passing through?for example I have 10 subnets:10.1.66.010.2.66.010.3.66.0..10.10.66.0Can I use one entry for this instead of using 10 entries???Thanks

Hi,Whether Cisco NAC 4.1 does system check continuously after being logged in?

we get an error message like the "warning boot variable added, but not a valid flash:/pix722.bin", when I update the pix like shown in the update manual

does asa supports multinetting?thnaks

I was configuring a workstation in the DMZ to FTP to a host on the inside of the firewall. The workstation is on the same subnet as the NAT address of the host. When attempting to FTP to the NAT host, I never see the FTP connection attempt in the sys...

I had a problem when i deleted an access-list. The GUI interface is deleting me de route associate whith the IP invoved in the access-list. This is the output in my syslog server when i deleted the ACL:Dec 5 16:24:21 192.168.157.1 : %PIX-5-111008: Us...

I'm having an issue with a couple phones over a VPN link. I have QoS on an ASA 5505 on the remote site and on the ASA5510 at the head end. class-map Voice1 match dscp ef match tunnel-group 99.164.119.206!policy-map qos class Voice1 priorityservice-po...