Network Security

Hi, everyone.Does anyone can help me with the following issue.Currently I'm employed on project where I need to install ASA with AIP-SSM module in existing mid size network. One of option of how to implement this is to make several (2) contexts each ...

Can anyone tell me how many routes a 5505 can contain.Our sales guys have sent one costumer a ASA5505 and would like us to announce 6k routes though this via ospf.Is this possible at all?? What is the limitation off the box./Arne

HelloCould anybody explain me why i can not launch vlan group in inline mode with IDSM-2 card ?I have appliance (4235) and i could plug it beetween switches (on trunks) and use VLAN groups to make fully virtualised IPS. Why i can not do the same with...

Hi all. I'm working on setting up a small companies network, and my main background is Enterprise MCSE type activities so you'll have to excuse my easy questions.I've configured a 5510 about 5 times now using the GUI and each time has resulted with t...

I have a hardware VPN tunnel from a PIX515e to a PIX501. Traffic in the tunnle is very bad. If I do a "sh crypto isakmp sa" is shows a state of "QM_IDLE". I am not sure if this is a problem? The any ideas on how I can troubleshoot this?

Hello,I am considering purchasing an ASA 5505 device for our remote offices. I was wondering, these remote sites have cable modems and DSL modems. Does the ASA 5505 work with these modems? Would I just plug my cable or DSL modem directly into the ASA...

I just purchased an ASA with SSM-10 IPS module and am doing the initial configuration. The SSM has IPS v5.1(6)E1 installed on it and I wanted to know if I should upgrade it to the new IPS v6 before configuring and putting it into production. If so ca...

Hi all,I am runnning an ASA5510, with interface configInside: 192.168.0.254/24Outside: 123.123.123.241/28DMZ: 123.123.123.238/28that mean usable IP range in DMZ is 123.123.123.225-238usable IP range in Outside is123.123.123.241-254123.123.123.254 is ...

hi everybody,does anyone see what's wrong with the acl? although udp 500 is allowed, the pix blocks the traffic. net1 - pix1 - router - pix2 - net2%PIX-7-710005: UDP request discarded from 10.4.1.1/1024 to outside:10.2.1.1/500%PIX-7-710005: UDP reque...

I'm new to the world of cisco. (asa 5510).I have a rack at a data center that has multiple IP addresses - 254.16.220.1 thru 254.16.220.62 (obviously not the acutal addresses.)I need to integrate it slowly into my rack, pulling one server behind it at...

Hi,I need to know if the ASA5505 is limited to only using it's switch for the clients in the LAN. What am I missing here?We have 1841 with ADSL modem. Just purchased ASA5505 and installed Serial card on 1841 for Internet Leased Line.Disconnected ADSL...