Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Some questions about Cisco IP Communicator Software:- What do you think about this Software? - Does it support 802.1q? I think that I need a NIC card working with 802.1q. Is it correct?Thats a lot.
hello all,2801 --- ISDN --- 2801(remote)Remote line has 2 numbers for 128k: xxxx6 and xxxx7when I test the first number it's ok withisdn test call int bri0/2/0 xxxx6But when I test with the second number, I receive the call but I have this errror in ...
Hello all,Is it possible to use one stanby IP address for 3 routers:- 1 Primary- 2 BackupConfiguration will seem that:Router 1:ip address 10.0.0.2 255.255.255.0standby 1 preemptstandby 1 priority 120standby 1 ip 10.0.0.1Router 2:ip address 10.0.0.3 2...
Hello all,Can you help me to choose the good Cisco Router to do ISDN in Bahamas?Does I need Cisco 802 or 801 ? I think the switch type is Basic-ni but really don't sure. Is the NT1 is including with the Cisco 802 ?Many thank for your help.
Hello all,I ask me about something:PC1----Inside-PIX-Outside----PC2I have a global on inside and nat on outside.I use static (out,in) @ipPC1 @ipPC1 because the computer on ouside need to connect on internal IP of the PC1. My question is, when pc2 sen...
Hi,It's not necessary to do RMA. I already do that, and issue is the same.TAC are working on it. There is currently no workaround.I have an opened TAC.
Hello, I have an open case on TAC. It's a really issue. I have a first workaround yesterday from cisco to enter in BIOS and shut and no shut NIC, but it's don't working anymore. This issue is going on development...
Hello,Is it ok for you with news appliances?Cisco sent me other appliances but i still have this issue. I impossible to have Static IP working properly! DHCP is always enable!...Thanks for your answer.. And i you have some ideas..
Hi,I have exactly the same issue with the same HW and same OS 4.1.1.23. All of you change the HW? I have two ACS with this HW. The HW is new, first time that I see that with ACS. And the issue is on both appliance.Is it working if you use DHCP?I see ...
