Hi all, I use FWSM and now I want to configure static NAT in FWSM: Diagram: Webserver : 192.0.2.6/32 , interface: insideNAT IP : 202.78.x.x /32 , interface: outside I want to configuse static NAT from Webserver to IP Puplic and everyone can connect t...
Network Security
Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- Technology and Support
- Security
- Network Security
Options
- Mark all as New
- Mark all as Read
- Float this item to the top
- Subscribe
- Bookmark
- Subscribe to RSS Feed
- Threaded format
- Linear Format
- Sort by Topic Start Date
Labels
-
AAA
(10) -
Access Control Server (ACS)
(6) -
Access List
(4) -
ACI
(10) -
Advanced Threats
(1) -
AMP for Endpoints
(1) -
AnyConnect
(3) -
APIs
(1) -
Appliances
(18) -
ASA
(1) -
ASR 1000 Series
(1) -
Branch Router
(2) -
Buying Recommendation
(87) -
Catalyst 2000
(1) -
Catalyst 3000
(2) -
Catalyst 4000
(1) -
Catalyst 6000
(1) -
Catalyst 8000
(1) -
Catalyst 9000
(2) -
Catalyst Switch
(3) -
Catalyst Wireless Controllers
(1) -
Cisco
(1) -
Cisco Adaptive Security Appliance (ASA)
(9,630) -
Cisco Bugs
(55) -
Cisco Cafe
(25) -
Cisco CLI Analyzer
(1) -
Cisco Cloud Services Router
(1) -
Cisco Defense Orchestrator (CDO)
(149) -
Cisco Firepower Device Manager (FDM)
(812) -
Cisco Firepower Management Center (FMC)
(2,909) -
Cisco Firepower Threat Defense (FTD)
(3,164) -
Cisco Press Cafe
(1) -
Cisco Secure Firewall Device Management (FDM)
(46) -
Cisco Secure Firewall Management Center (FMC)
(239) -
Cisco Secure Firewall Threat Defense (FTD)
(292) -
Cisco Security Cloud Control
(16) -
Cisco Security Manager (CSM)
(3) -
Cisco Software
(20) -
CISCO START ANZ
(1) -
Cisco Threat Response
(1) -
Cisco Vulnerability Management
(46) -
Cloud
(1) -
Cloud Provisioning
(1) -
Cloud Security
(3) -
Community Bug or Issue
(1) -
Community Feedback Forum
(32) -
Community Ideas
(18) -
Compliance and Posture
(1) -
Crypto
(1) -
CSC Content with No Valid Community to Post
(1) -
CUBE
(1) -
CUCM
(1) -
Data Center Networking
(1) -
Device Admin
(14) -
EEM Scripting
(1) -
Emergency Responder
(1) -
Endpoint Security
(6) -
Enterprise Agreement
(1) -
Event Analysis
(264) -
FirePOWER
(1) -
Firepower Chassis Manager (FCM)
(2) -
Firepower Device Manager (FDM)
(16) -
Firepower Management Center (FMC)
(408) -
Firepower Threat Defense (FTD)
(221) -
Firewall Migration Tool (FMT)
(37) -
Firewalls
(1,171) -
FMC
(1) -
General
(2) -
Guest
(1) -
Identity Services Engine (ISE)
(9) -
IE3300
(1) -
Integrated Security
(8) -
Integrated Security Architecture
(1) -
Integrations
(4) -
Investigation
(2) -
iOS
(1) -
IPS and IDS
(6,580) -
IPS and IDS1
(1) -
IPS-IDS
(1) -
IPSEC
(1) -
IPv6 Configuration
(1) -
ISE
(1) -
LAN Switching
(7) -
License
(324) -
MPLS
(1) -
Multicloud Defense
(3) -
Network Management
(94) -
Network Security
(2) -
Networking
(1) -
NFVIS
(1) -
NGFW Firewalls
(37,594) -
NGIPS
(1,874) -
Online Tools and Resources
(1) -
Open Source and Open Standards
(1) -
Optical Networking
(3) -
Optics
(1) -
Other Automation Analytics Topics
(1) -
Other Collaboration Topics
(1) -
Other Community Feedback
(5) -
Other Firewalls
(1) -
Other IP Telephony
(1) -
Other NAC
(18) -
Other Network
(2) -
Other Network Security Topics
(10,792) -
Other Networking
(9) -
Other Routers
(9) -
Other Routing
(24) -
Other Routing and Switching topics
(2) -
Other Security
(1) -
Other Security Topics
(18) -
Other Switches
(12) -
Other Switching
(4) -
Other VPN Topics
(1) -
Passive Identity
(1) -
Physical Security
(21) -
Policy and Access
(2) -
Prioritization
(3) -
Remote Access
(2) -
Room Endpoints
(1) -
Routing Protocols
(9) -
SD-WAN Security
(1) -
Secure Network Analytics
(1) -
Security
(4) -
Security Management
(645) -
Segmentation
(3) -
Service Providers
(1) -
Small Business Routers
(5) -
Small Business Security
(2) -
Sourcefire
(2) -
Support
(2) -
Threat Containment
(6) -
Threat Defense
(1) -
Threat Grid
(1) -
Unified Computing System (UCS)
(1) -
Voice Gateways
(1) -
VPN
(29) -
VPN and AnyConnect
(1) -
Vulnerability Management
(46) -
WAN
(8) -
Web Security
(5) -
Webex Teams
(1) -
Wired
(3) -
Wireless Security
(1)
- « Previous
- Next »
Forum Posts
Resolved! ASA5505 outside implicit rule
I can't seem to get incoming traffic pass the implicit outside rule. I've configured the below static route and access-list which I hope means anything source tcp address can get through the outside interface on port 1997 only and the static NAT send...
Hi,I need to have a record of the sessions got established on the ASA5500. I do not have Syslog server, yet. Therefore, I will keep this info. at the FW buffer.My question is, what severity level is legitimate sessions got established from the Outsid...
I dont think my sysopt connection permit-ipsec is working, as even if I add that line I am not able to communicate over RA-VPN (though its getting establishing) unless I explicitly allow that traffic using ACL. Any other way to check if its working, ...
HiI am using putyy 0.60.0.0. I have two pix firewall . When I am using putty to see the configuration of firewall the one of the firewall sh run is good work and i show see step by step but another firewall when i access by putty then i generate comm...
Hi Friends,I need some information about Failover configuration with ASA.I have an ASA5540 Box with failover unit, I want to configure statful fail over between this. plz find my queries1) Do i require a dedicated intrerface for configuring stateful ...
how do i block ping from outside network to my internal network
Hey guys/gals:I want to put a web server on my DMZ. I set up the IP address on the PIX's DMZ. How can get my web server access to my inside network and vice versa? I don't know what to do next.I already created a VLAN in my network for this network 1...
I am running FWSM 3.2(1) code and catalyst 6500 IOS 12.2(SXF11)in the switch:vlan 100 name outsidevlan 200 name insideint vlan 100 description - outside ip address 10.128.252.1 255.255.255.0int vlan 200 description - inside no ip addressin the FWSM c...
I am configuring an ASA with a web page linking to and internal IIS server page delivering Microsoft's Remote Desktop Web Connection page. I have configured Application Access (port forwarding) and successfully tested the localhost:port# connection w...
Dear guysi can not console to my PIX 525i tried many speeds and condition but nothing! also the cable and other component are ok.any hint?
Correct me if I am wrong, the Cisco Pix by default will only allow packets from the outside to inside if there is an entry for it in it's state table.Other than CBAC's ability to filter on the application layer via control packets, is there any other...
If funds only allow for one 4215(Network IPS) where would be the best place to locate it?
I do have an issue with Firewall load balancing with Server Load balancing feature. If want to achieve this we need to create one loop-back interface address or secondary ip address in BOTH firewall(ASA) . by using SLB dispatched mode.. Any one can s...
Hello all, I require some assistance in regards to passing multicast traffic through a checkpoint firewall. We have a server which resides on a screened subnet behind a firewall on a 3750 running base image. It is the multicast source. The clients re...
Learn, share, save
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Unanswered Topics
| Subject | Author | Posted |
|---|---|---|
| 06-24-2026 08:00 AM | ||
| 05-26-2026 07:54 AM | ||
| 05-02-2026 06:09 AM | ||
| 04-30-2026 12:46 AM | ||
| 04-24-2026 07:04 AM |
New solutions
Top Solution Authors
| User | Count |
|---|---|
| 5 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |
