Network Security

Hello Everyone,Is it possible to deploy active/active failover while Load balancing 2 ISPs??I will be willing to send you attachments if you want to check the setup.. thanx to all

How can I tell if PDM is installed on my Pix 515e?Much appreciated

I have see a couple of alerts from my IDSM for signature 6005/0 "Unencrypted SSL Traffic." The target ip address is one of my ssl proxy ip addresses (on CSM-S) tcp port 443. An example of the unencrypted traffic sent:GET http://www.yahoo.com/ HTTP/1....

We are using ASA 8.0 WebVPN to provide clientless SSL VPN access with the Java plug-ins for Windows Terminal Services (RDP), SSH and VNC. However, those plugins are a little bit outdated and do not support all current protocl versions, e.g. the RDP p...

hi,kindly what are the procedures to update my license key....and i need to update IPS from 5.1.5E to 5.1.6 what are the procedures ? and so i need updating my signatures i need the procedures too?thank you.

Can somebody guide me on how to upgrade an ASA K8 bundle that i've purchased recently to a K9 bundle? thanksbrian

Hello.Routing truble on PIX ??inside PC-10.100.4.111 can't connected to remote sites PC-10.100.110.111 etc..the pix are default gateway on PC.It's some way to do this ?I have one PIX525 Version 7.2(2) two VPN3005 Version 4.7.2.L one WS-C4006 Version ...

Can I use a 2811 to do reverse proxy.

Hello!On PIX 515E I need access from a real IP x.x.x.x (outside interface) to inside IP 10.1.1.2 (inside interface) without NAT - for test purposes. When I try to access from the real IP x.x.x.x inside IP 10.1.1.2 PIX sends error messages to syslog: ...

Hi all,I'm working with an updated versione of LMS 2.4 (RME 3.5) and my customers have many Cisco Catalyst Express 500.I can't find in Cisco docs any reference to the Cat500, so I suppose is not officially supported.Next month we will migrate to LMS2...

Dear sir,Iam having pix 506E iwant to know weather it was junune cisco or not how can i find out.My s.no:88810390977Plz find out weather it was cisco or notI purchased this from WIPROplz conform me.Regardssrinivas.D9246571397

Hi,I have a requirement to get Sun RPC through a Pix i have running version 6.3(3).Is this possible without having to open up a high ports range of ports ?is there a Fixup command (i cant seem to find one) ?Any help would be greatThanks

Recently, I updated the OS and ASDM on the PIX 515E. It is now OS 8.0(2) ASDM 6.0(2). When the PIX is rebooted and logged in via terminal session, the "show conn" command gives a clean connection state. If I set terminal pager 0, and then do a "show ...