Network Security

I have a pix 501 with the outside interface set to dhcp.The inside interface is 10.6.1.1How do I forward ftp traffic to 10.6.1.10? also I want to forward port 15000 to port 3389 to host 10.6.1.11 and finally port 80 traffice to 10.6.1.12I tried a sta...

I was wondering if I could ask you a question regarding the pix. We are looking into an alternative way of working around the isa server. We are looking into having a connection from the pix to the switch. Could we configure on the pix to connect dir...

Is there a command I can enter in my config on the pix to log inbound traffic that is trying to come through a certain port? If so what is the command and how do I access the log?

I need to open port 3306 for inbound traffic on pix 515 E so i added the follwing line in after my other ports:access-list InboundFilter permit tcp any any eq 3306I also have the line:static (inside,outside) (my public removed for security) 192.168.1...

The only way I've found to get info on a specific ip is by capturing the interface and doing a | include.Without setting up an entirely new Access list is there any way to dump a specific ip adress?

Suppose I setup three zone; outside, inside, and dmz. I have one host in each of the zone for a total of three.Both Outside and DMZ are public addresses. Inside is of course using private address. If I label HostA in outside zoneHostB in dmz zoneHost...

Hello,Guyswhy cann't I open this URL of NAC flash demo,Error appears under the web when I openUrl:http://www.cisco.com/cdc_content_elements/flash/nac/demo.htm.It is error all the same after I installed flash player.How do I open this Url.Thank you!Re...

Hi,I have a cisco 2811 router which is connected to 4 routed vlans. I would like to control the bandwidth for the users on these vlan because these vlans are public hotspots. Some users are choking the whole bandwidth due to which others are unable t...

Can VMS be used to upgrade the IPS version on sensors? Or do you have to log into each sensor and upgrade that way?

Hi I have a pix 501 that keeps rebooting and I get the following message: "Checksum verification on uncompressed PIX image failed" How can I fix this?Thanks.

Our company forgot the Administrator password of NM-CIDS installed on 3600 router. Now, we can't login on this device. Therefore, I like to know how to do password recovery on this NM-CIDS.ThanksRegards.

Hello. I have a problem. I have a ms vpn l2tp/ipsec server behind a router cisco. The router cisco have a public ip and it nat 3 vpn port of vpn l2tp/ipsec to vpn server ( udp 500,1701 & 4500). But it doesnt conect. If i try the vpn server with a cli...

Hi!I need to know how can i change the console password in Pix 515.Thanks a lot.

Hi friends,I am unable to make FWSM failover work in an inter-chassis configuration:6509 switch - 12.2(18) FWSM - 3.1Here's the brief-up of the configs that i have done:1. There are two 6509's where the FWSM's are inserted in the same slot and both F...