Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have been told that we need to shutdown all unused ports on all the switches. Since this is a lot of work, I have thought about giving this task to the helpdesk but I am afraid of them making a mistake; therefore, I would like to see if there...
Hi, Here is my existing layout: CompanyNetwork -- MetroE -- (Fa)Router(Fa) -- switch -- InternalLan Both Fastethernet intefaces in the router are taken, one is being used for the MetroE, the other one is for the internal vlan. We are planning to...
Hi, I am working on a back-to-back frame-relay lab enviroment. I have the routers configured but for some reason I can route between the two interfaces. I am using Wic 1DSU T1 cards. I have tried routing protocols, I can't do frame-relay map, etc ...
Hi, I am configuring snmp so I can use the Cisco Network Assistant to monitor part of the network. I have created two communities with different names. Something like this: baycom and baycomrw. The one with read and write access is associated with ...
Hi, I have configured ntp synchronization for all the devices in my network. But I do have some questions regarding the time format: 1. Is there any way to change the time format in my router or switch? Right now it displays the 24 hours time form...
Hi, You should post your switch configuration in order for us to see how they are connected but I would like to make a suggestion, If you are going from your internal 10.0.10.x network out through the router 148.x.x.x most likely you need to crea...
Hi, Rapid spanning-tree also permits you to configure a secondary root switch in case the primary fails. It also has many features such as bpud guard, root guard, etc to maintain the network's integrity.
Hi, Please check the link below for more information on how to configure and ISDN link. http://www.cisco.com/en/US/tech/tk801/tk379/technologies_configuration_example09186a0080094091.shtml Let me know if it helps. RG
Hi, The above statement regarding your internet connection is correct but personally I will use GLBP (Gateway Load Balancing Protocol). It allows to use the two circuits at the same time unlike HSRP that uses only one. The second one will be in sta...
Hi, My understanding is that they are different. You use the pvlanid when you are going to configure a switch port where you need to specify the Vlan ID, for example: switchport access vlan "vlanid" or spanning-tree vlan "vlanid" Tagging is a m...
