Network Security

Error Message:Error converting config. Install aborted. Any help? Thanks in advance

i have two internet connections with one PIX for each connection i want to make configuration to make the backup between the two connections

Could anyone help me reseting all sigs to solve the problem with the upgrading from 4.1(5) IDS to 5.0??

Hi, we are having some voice quality issues with with our home users who are running CISCO VOIP from home. we have a simple setup:[7960phone]-[pix501]-[cablemodem]Pix 501. 6.2ver does the VPN to our corporate network.can i prioritize the VOIP traffic...

Hi, Can you look at what I believe to be a false positive for sig 5551Thanks,evIdsAlert: eventId=1116783457905897506 severity=high vendor=Cisco originator: hostId: Vintage01 appName: sensorApp appInstanceId: 340 time: 2005/11/01 01:06:33 2005/10/31 1...

This signature triggers on =shell: anywhere in the tcp stream.Isn't there a way to tighten this up? If fires even when I got to the Cisco MySDN page for this signature (because it has the word =shell: in the html returned).

Hi. I set up an ASA 5520, and while consoled into it all seems well. I did some basic tests, can get out to the internet and all is well. I plug a client into it, and it gets its dhcp address just fine, including dns, gateway etc. however the client ...

I have configured my PIX-525 running version 6.3 to send the system messages to it's internal buffer.However the messages are not time-stamped.I have also enabled the logging timestamp command.I read that the logging timestamp command only "timestamp...

Is possible Upgrading from 4.1 IPS to 5.0 over ssh? or must it be over console?

I noticed the hard coded speed and duplex settings for interface Management 0/0 do not replicate from the primary to the standby ASA. Do I have to manually hard code these on the secondary? Will the settings keep after the unit restart since it gets ...

When i click on Query Interfaces (IPS Manager: Configuration > Settings > Interfaces) i get the following error: An error occurred trying to get the interface information. An error occurred while trying to determine the sensor version. Detail = Error...

Hi all,I have very interesting question related to PIX 525. We have sometimes problems with temperature in our servers room and each time temperature rises over 30 C our PIX starts block every traffic and we cannot connect to it via SSH and console t...

I'm searching all over Cisco.com for information on installing CSA 5.1 agent on Microsoft Clusters with Teamed Broadcom NICs, but I can't find any information other than "this is supported" in the installation guide.Does anyone know if there is a pro...

After upgrading to the 5.0.0.186 release, I have several servers that will not remain in thir groups, even after being added to them several times. It seems to happen after they are rebooted. A Critical Error is generated, saying no policies are bein...