Network Security

Does anyone have trouble telneting to pix after upgrading software? Configuration is still correct, the pix can ping the server (10.98.0.X) where telnet is allowed. Also, another server running snmp (10.98.0.X) cannot find the pix either. Both device...

Hello,We are trying to figure out how to setup a port on our Cat4006 switch to be in promiscuous mode. We already have multiple VLAN's and I have read the details on setting up PVLAN's I am just not sure if this would affect our existing port configu...

I have many problems with the csa 4.5.1.x. When i installed the csa on any client workstation, the csa can not synchronize with the csa mc. The communication between the two peers is ok. I can telnet to the ssl port 443 and the communication port 540...

evError: eventId=1133224443501623136 severity=error vendor=Cisco originator: hostId: <name> appName: cidwebserver appInstanceId: 344 time: 1961/11/06 20:16:34 1961/11/06 15:16:34 GMT-05:00 errorMessage: name=errSystemError WebSession::sessionTask(2) ...

Folks, I have been trying to get an answering to a question pertaining IPS, but, no one (not even TAC) have been able to give me a definite answer.We have a core 6500 series switch with 10 Vlans defined. We have IPS blade installed as well on the swi...

Has anyone got any information on acceptable CPU usage on PIX, my reason for asking is that I am constantly observing 88 – 91% CPU usage on our PIX 515 running 6.2(1), I can not find any information on cisco.com.Any ideas / thoughts will be greatly a...

I am getting the following error message, when i tried to open EVENTS section in Security Monitor of IDS MC 1.2

how can i send memory use percent to third part sofeware.if use snmp ,then which mib should i used?thank you very much?

Hello, I upgraded our our Pix's OS from 6.3(4) to 6.3(5). We have a 14 site VPN Meshed network with 506s at remote sites and a 515 at the main site. After the upgrade we have been exipiriencing throughput issues at the main site (through the 515). In...

We are trying to establish GRE/IP tunnel with Cisco GSR 12008 but are not able to do that. The config is simple:interface Tunnel0 description GRE-tunnel0-1 ip address a.b.c.d 255.255.255.252 no ip directed-broadcast load-interval 30 keepalive 10 3 tu...

what is the meaning of this error message.An error occurred while running the update script on the sensor named test. Detail = CLI Error: "tls trusted-host ip-address 127.0.0.1 port 443 handshake incomplete."

is it possible to redirect traffic like http or smtp to a speficif IP? I have a Cisco Pix 515E. Thanks.

I upgraded our PIX 515e from 6.3(4) to 7.0(4) last night, and now I am seeing Packet Drops on the interfaces. I am seeing this via SNMP (see attached errors and traffic for one i/f over the last 2 days) and the PIX interface stats; Traffic Statistics...

Hello,does the dhcpd of the Cisco Pix 500 or ASA5500 systems provide the featureof "manual IP address allocation"?This means, that a client's IP address is assigned by the network administrator, and DHCP is usedsimply to convey the assigned address t...