Network Security

PIX 501, 6.3(4). Trying to allow client on inside using Outlook Express to ISP Mail server. I believe Outlook Express uses SMTP to send mail and POP3 to retrieve it. Wondering what sort of config is required as I am not sure if server or client initi...

My pix has three interfaces.one is used to inside interface .The others(two) are used outside interfaces.the two outside interfaces can implement load balance.How can I do. thanks!

i have two pix535 configed for failover. there is a route config(to outside direct port) can't replication. i reload standy pix,and use write standy command ,there also is 'nt the route config. the standby pix's outside port static is"wait",and the r...

our company bought one pix firewall 515 from EBAY on line shopping. we configure the firewall and it is working fine but we notice that 3DES is disable in our firewall i contact the cisco licence to get the 3des licence they send the activation-key i...

Hello,Normally, they use only two ports as External and Internal Interfaces. Now they are using PIX-4FE-66 to get extra 4 interfaces card for Servers Farm. The problem is the new 4 interfaces do not function or work properly. We cannot access or ping...

Hello,We migrated from a pix 515R using a outside and inside interfaces. The old pix has a static ip for the inside interface so we use all the class c ip's on the inside.We are now migrating to a ASA 5520 but now with the following interfaces. outsi...

Dear All,I have a client with the attached Network topolog file. He wants to install his PIX firewall in the position showed in the topology file…His request is to route the internal traffic between his branches and internet using his PIX firewall….A...

Hi,how to enable telnet to pix outside interface.I try to connect with telnet to a router in outside lan and then i would connect with telnet form router to pix.Router have ip address 10.10.10.1 and Pix device have ip address 10.10.10.2.I have tried ...

Dear all,We have a PIX 525 with failover bundle. I would like to know how to upgrade my OS from ver 6.3 to 7.0 in both the Active and Standby firewall.I would also like to know the bugs/problems that we might face after upgradation and whether it sup...

I have a PIX 515E with boot problem. These are the lines I received from the console:CISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee32 MB RAMPCI Device Table.Bus Dev Func VendID DevID Class Irq 00 00 00 ...

Hi,I think this is probably the best place to ask! I'm not really interested in the certification...Does anyone know if one of the Cisco courses gives good training on PIX v7.0 and for the Firewall Services Module, also if the training covers topics ...

Is it a way to allow broadcast on a defined port through a PIX. For example host A broadcasts on udp port 234 and is connected to interface A on the PIX. Host B is connected to interface B on the same PIX and should see this broadcast.

Hi, I´m in urgent need for help. I have bought an Pix 515E for the company.First i connected the firewall and all outbound traffic was ok, but naturally no inbound traffic as mail got through.So i tried to set up some rules (2), and they didn´t work ...

Hello, I've been looking through the forums and have been seeing different answers to this:Say I have two PIX 515e's running V7 in failover - I've got 6 interfaces: outside, dmz1, dmz2, dmz3, failover and inside.Can I run multiple VLANs in dmz2 for e...