Network Security

Hi all,I want to do an upgrade of a PIX 515 and its failover unit from 6.1 to 6.3. I just want to make sure I have this right:1) Get a new activation key from [email protected]. Does this apply for both primary and secondary? The FAQ states that it...

Hello All,I have a problem with Configuration of Pix 515 (3 interfaces). I have Bloomberg router on the DMZ network. It worked fine, until I tried to filter from inside network. I've read Bloomberg manual. They recommend opening 2 ranges of ports:tcp...

I have a node on the outside of our PIX that needs to communicate back to a device on the inside of the PIX. It is for TACACS authentication. For some reason I can't get it to work. I tried a conduit like:"conduit permit ip host <IP of device on outs...

Does anyone know where I can find the MIBS for the traps sent for each alert in IDS Version 5.0I have looked all over the ftp and web on the cisco site and cannot find them. Thanks,

If I aleady have a vms basic 5 device restricted license and a cisco 4215 ids system,did i need to purchase vms license to implement csa agent through my network?

HiDoes anyone have any idea of how to configure a PIX 506E so it can do netflows for my whole network.I want to plug my upstream provider into it but will also plug my sub networks into it as well.RegardsMalcolm

Apologies in advance for the newbie question but I can't seem to figure out the straightforward process to get this done.Working with a Cisco 4215 running 4.1(4). All I'm looking to do is disable 'ICMP Network Sweep w/Echo' (SIGID 2100, subSIGID 0) v...

Hello, I have a pix firewall 506e which IOS ver.4.3. After I reloaded it, it just shows the below message: CISCO SYSTEMS PIX FIREWALL Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73 Compiled by morlee 32 MB RAM PCI Device Table. Bus Dev Func VendI...

Hi, I have IDS 4215 and a VMS, i had no free space problem on the machine and i solved it, now when i try to run anyservice within the IDS MMC such as editing the signatures configuration or diplaying the sensors that are supposed to be added to the ...

Hi,I have 2 questions:1, Can I undo the chages to the last generated "position"? In other words, clear all chages and keep the generated configuration.2, Can I migrate backwards to an older generated configuration?Thanks!

Hi,I have a problem installing SSL Certitificate for VPN3000, I have requested the SSL request in right order to Globalsign. As I have gone through the cisco forums, I have also Installed the CA chain in certificate authorities on vpn.I have go the c...

I have an IDS4215, i have tried to update the signature through FTP and through IDS MC without success. I need a proceedure on how to achieve this both ways!!

Hello!I have 3 i-faces on PIX515: Inside, DMZ and Outside. DMZ and Outside have public IP, Inside has private IP.I want to have access between Outside<--->DMZ<--->Inside without any translation(my mail-server located in DMZ and must be accessible fro...

I have a PIX 501 and when I set it took the defaults. I do have a VPN to another 501. I'd like to block all unneeded ports both incoming and out going (things like IM and Limewire). I've looked through some books and some cisco documentation but I'm ...