Network Security

I need to allow only one IP address (the one for proxy server) to browse through Pix firewall to Internet.What will be the commands in PIX firewall to block the traffic to Internet from all the inside network 10.2.1.x but only allow 10.2.1.10 (Proxy ...

We are running VMS MC 2.0.2 for all IDS. While trying to Deploy a job in VMS Management Center for IDS Sensors, we received the following error: "Generate failed. The configuration of Sensor xxxxx does not contain any sensing interfaces. The configur...

WILL THE VPN CLIENT FUNCTION CORRECTLY INSTALLED ON A WORKSTATION IN A TOKEN-RING NETWORK?

When I power up or connect the PIX 501 to the local network, even though it only has one cable to the switch (an AOpen AOW-616 if that helps any), it knocks out the local network, including blocking pings and file&print services. Disconnect the PIX, ...

I have been attempting to creat a trunk between a PIX and CatOS. The only VLANs on the trunk are 11 and 20. I've tried the following, but it didn't work. Any ideas? Thank you.PIX:interface ethernet1 vlan11 physicalinterface ethernet1 vlan20 logical.....

I have a 4215, running 5.0.4-S149. In an attempt to update it to S191 (and then later S192) I noticed that packets start getting dropped, inbound and outbound, while running at that signature level. Connectionless protocols seem to work ok. However c...

Hi,I need to restrict traffic for an RA VPN. Is it best to do this with ACLs on the interfaces or through CPP?I've tried both to no avail and want to make sure I'm on the right track before delving too deep.Thanks!

I need your advice on VPN Conc log analyzer. I am using Kiwi Syslog Enterprise as syslog server. Does any body know or have a recommendation for a good VPN log analyzer that analyzes VPN logs and spit out a report?

Client of mine purchased the PIX 515E-AA-FE-BUN, and now wants the PIX 515E-UR-FE-BUN.How can I get the unrestricted bundle on the current PIX 515E-AA-FE-BUN? Is it a matter of just downloading the right software from Cisco.com or do I have to get Ci...

Is it possible to have two different user databases on same Cisco Secure ACS server, and one database for TACACS+ protocol and the other for RADIUS protocol? Or, can one protocol, i.e. RADIUS, have two different databases on same Cisco Secure ACS ser...

I just purchased a PIX 501 and thought I could get it configured without problemssince my set-up is simple. I also have experience with Linksys and Sonicwalls but since I'm in the big leagues now with Cisco, I'mbeing humbled.I have a simple set up. 1...

I have a PIX 501 configured with an internal address of 192.168.1.xI also have a Linksys wireless Access point that handles my wireless workstations. With a user license of 10 users, I wanted to have the wireless PCs all go thru the Linksys and hit t...

a device that has been segmented on a vlan interface on the pix has been assigned a dynamic translation, but can't seem to get correct translation:here's a snap of the config:nat-controlnat (inside) 0 0.0.0.0 0.0.0.0static (Aspect-vlan,Outside) 146.7...