Network Security

Folks, I am very new to the IDS on the 6500. I have give it an ip address but can not make it ping the default gateway. How do i put the interface in the right vlan???Can i use a web based interface to collect logs or manage the idsm using a GUI.Than...

Problem bouncing throw a PIX.In my company we have a Hosted Rack white a PIX firewall. The firewall is mange by the Hosting Company.There say the following about my problem, white bouncing from the inside of the firewall:Firewall setup doesn't allow ...

I connect with vpn client v 4.0.3f to the pix 501 v6.2, however I can access resources on the remote lan only after I initiate some kind of connection from the remote lan to the vpn client (a ping for example).Could the fact that I don't get any dhcp...

IDS signature update not working on IDS-4215 via Ciscoworks VMS. IDS-4215 Cisco systems IDS version 4.1(4)S91. Trying to deploy signature update IDS-sig-4.1-4-S162.zip.The following error is been noted in the audit report:"Sensor update for LDS_SENSO...

Dear all,I have a cisco1700 series route which contains two ethernet ports.I don't want to use serial ports.I have a broad band connection(i.e. through smart bridge). One etherent is connected to smart bridge. & other one to lan. How can i configure ...

We need to apply IDS-sig-4.1-4-S162.rpm.pkg to our Ciscoworks SC. Is there an IDS-sig-4.1-4-S162.zip which included the NSDB and other required files?Thanks,Simone.

hi..first i would like thanks Cisco to give me this great Opportunity to ask the professional..my problem is that i cant telnet or run the PDM from outside the network, although through an IPSEC tunnel as Cisco Advise.. !! I can telnet and run the PD...

I'd like to know if there is an easy way to view events that caused the IDS to shun a host.I understand there is Event Viewer standalone, with VMS and IDM. However, with event viewer, it is difficult to view (search) a specific event that occurred in...

Hiwe are planning to deploy cisco IPS 4200 series on our network. We have a redundant network so what I need is an a device that would react to threats(via acl, shun, resets) while in passive mode ( using span or taps). couple of questions1- Is this ...

All of a sudden, I've started getting alerts on RPC WinNuke Sig#:3345 from a domain controller to workstations on the internal network. I am unable to find anything that has changed, nor can I find anything that would cause this event to be triggered...

I have a PIX 501 running 6.3(3) with a 10-user license. It has 3 IP addresses on the inside. I get messages %PIX-4-407001: Deny traffic for local-host interface:10.204.136.131, license limit of 10 exceeded. This message is produced for all three insi...

Hi all,i installed S. Agent on my xp desktop and i see on cisco doc that it is possible to activate also a firewall embedded into security agent.Where i could active this feature? Before made an agent kit ??Thnaks in advanceMarco

Hi all,could someone tell me what is the difference between these GUI Interfaces which i found on my VMS 2.3 system????1) VPN/Security Man. Solution --> IDS Sensor2) VPN/Security Man. Solution --> Administration --> IDS SensorI think there is no diff...

Hi all,i need 2 infos about security agent v.4.51) If i have a host with sec. agent installed and it is not connected with CSAMC,does it store event in a databese or not?? Then If i connect this host to my network after 2/3 days, the agent will send ...