Network Security

where can I find some documentation on how to setup cisco routers to use GRE to encapsulate IPX in order to pass through a pix firewall? I need to have a remote site with IPX needs to attach to headquarters. The traffic will be passing through a PIX ...

I try to configure my PIX515E (version 6.3.2) with a PIX Device Manager (version 3.0.1). I've got already a configuration (from an other PIX-PIX515 version 6.3.2), so I want to configure my new PIX as the old one, but with the PDM.And I've got some p...

I have an old PIX 501 that still needs to open ports 80 and 443 for external access to my internal 192.168.1.10 computer. I can't figure out where I'm going wrong, any feedback would be greatly appreciated.PIX Version 6.1(4)nameif ethernet0 outside s...

I have an issue where CNN and a few other odd sites load exremely slow through a PIX (6.3(1)) that uses Websense 5.2. The pix is at a remote site with a T1, but there is very little other traffic on the pipe. I'm using UDP to communicate to the webse...

HOW DO I IMPLEMENT CISCO NAC (NETWORK ADMISSION CONTROL) IN CISCO ROUTERS/SWITCHES BESIDES SERVERS AND DESKTOP ????

Is there a way to log the Statistics( i.e. Top Ten List) that a VPN concentrator 3005 produces? The problem that I have is that when I view the Statistics throught a web browser it's only for the last day or so.

Can i aply quality of service to a vpn on a PIX firewall.if, it is possible how do i do it ??thank you Alejandro

Hi, AllJust wondering what is the point of applying virtual telnet on pix. Since we can use downloadable acl at the ACS for pix, the user shall be able to access whatever he want after successfully passing the authentication (based on the downloaded ...

I am working with a client who has an older PIX 520, version 4.2(5). I would like to connect using SSH. Is that possible in this version? I can set the telnet, but I would prefer to use SSH for outside connectivity.thanks,Jim

HiIs it possible to do any of this in the Pix:1) Static DHCP lease. I e configure the Pix's dhcpd to always give a dhcp client with Mac-address xxx the same IP-address yyy?2) Static ARP entry? I e to configure the pix ARP-table (on inside) that the M...

Is it possible without WCCP, to configure a Content Engine 7305 to do real ftp proxy.Like on port 21, and use user@site:port ?

We have a ftp server on 192.168.0.4 on the inside interface of our network. The server is running an FTP Server, but we cannot get traffic from the outside interface.I have attached a copy of our config should anyone be able to help. The private ips ...

I have used this Pix 501 at two locations since purchased new 7 months ago (Whats the warranty), the first location had the same problem- Massive Speed Loss(1.5/1.5 was running at 100/300), which the ISP tech support thought the Pix could not handle ...

Hi ,I have the following scenario: R7 --- INSIDE --- PIX ----- OUTSIDE -------- R5, R6RIP VERSION 2 is running between the PIX and R5,R6, R7As you can see the PIX is learning the loopbacks of R5,R6 and R7R5: 15.15.15.15R6: 16.16.16.16R7: 17.17.17.17p...

WE have a PIX 515e running 6.3 FOSIs it possible to stop all mails from three ip address and allow the rest of mails from all mail servers using rule sets in PIX .We belive these three ip addresses are spammers and would like to block them at the per...