Network Security

according to PIX Installation Guide, you can have up to 8 interfaces on a PIX 525 (see Note at URL : http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_61/pix_ig/pix525.htm#xtocid11according to PIX Configuration Guide, you can have up to 6...

In a failover configuration, if I do a show fail on the active PIX, I see thisfor the cable status for the insideinterface on the secondary host:Interface Inside(10.0.0.2):Testing.On the active PIX the status is normal and if I look on the secondary ...

We have a solaris box behind a pix firewall. We would like to not allow port 80 traffic to the server for security reasons and only allow 443. But if users in advertently go to the http:// URL instead of the https:// - they get a page not found error...

Is is possible to block http downloading on a pix 515 or do I need a 3rd party prorgam??

I am trying to get my PIX to NAT addresses from a DMZ interface out the outside interface. If I use a block of addresses from the subnet of my outside interface it will not NAT them. Here is my pertinent config info:ip address outside 10.1.116.2 255....

My Cisco 3005 VPN Concentrator keeps timeing out for some connections. When I look through the logs the only thing I see is:626 07/03/2002 00:06:30.890 SEV=5 IP/50 RPT=192 Headend received TCP ACK pkt from client 68.38.72.43, TCP source port 1195627 ...

If I remove that line what will happen?I want to be able to have an ACL applied to the inside interface of the PIX to control what type of unencrypted traffic is allowed inside. Do I need to remove the 'sysopt connection permit-ipsec' command in orde...

Anybody knows about PIX firewalls Syslog server?

What is the maximum memory I can put on a PIX515?

I noticed that 2 of our PIX firewalls have a difference in the configuration; one has the "names" command, and the other has "no names". What is this used for?

If access lists are disabled on the PIX Firewall, does that mean all traffic is blocked?

how to prevent users in a campus from using chat programs with a pix firewall. Do you know the ports of icq and irc.

Oracle connections through our Cisco PIX 515-UR are timing out. Are there any commands for timeouts on the PIX that might affect an Oracle connection?

When I add a static route on a PIX for the inside i/f, to redirect traffic to a router on the inside network, the traffic doesnt route to the router. e.g. a PC has DG=192.168.1.254 which is the inside i/f of the PIX. Its trying to reach 192.168.2.0 n...

How do you remove the pix configuration so I can start from a fresh config?