Network Security

Hi everybody.I've been searching these forum-pages, and found a lot about alias, but I haven't been able to cover "my" senario:Here is the point:How do I configure the Pix, doing Alias when the "Public" DNS servers are located on a DMZ, with "Interna...

We have a 3015 configured to authenticate against a windows radius server and that works fine, this is our primary means.I am trying to also use a local account on the VPN, but when I try to authenticate with that account the concentrator tries to us...

I am using the Pix 501 for all incomming and outgoing routes for my network. I am going to start hosting my own mail and web. I can get to the mail server and web server from the outside just fine. I cannot access the web page from anywhere inside my...

My syslog showed a 105005 then 105008 then 105009 message.I logged into the pix and did a "show fail" and everything looks fine except for one of the interfaces on the other host:Interface outside (my ip address here): TestingIt never changes from te...

Hi all,I'm trying to setup a *simple* Windows to Pix VPN connection. Rather than have each client download the VPN Client (on a dialup connection, this could take quite a while and if I'm supposed to dial-in and fix something NOW, that wouldn't work)...

Does anyone know of any interoperability issues with configuring a VPN between a Nortel Contivity switch and a PIX 515?Thanks in advance for any help....

Hi,Is RMON supported for cisco 7513,i am running 12.1(7).If yes,how do we enable it. Any help on this appreciated....Thanks

I understand that as in any firewall the PIX 501 sits in between the DSL interface and the LAN. It is not possible to connect to a USB type ADSL modem as there is only an ethernet point on this unit. I have an ADSL router which includes its own modem...

Will PIX VPN software ever support ESP packet encapsulation in TCP/UDP just like the VPN Concetrator does?Thanks!

Hi, I am trying to install PDM on PIX 520. I copied the image (2.1.1) on to the firewall using tftp. But after reload I cannot see the PDM image listed in the output. But when I try to access the PIX through explorer (using https) it gives me the ena...

I’ve configured a CISCO PIX 515 E- unrestricted IOS v. 6.1 with 6 interfaces for a Customer. We have hosts on Windows 2000 and NT platform spread in each subnet. I’ve implemented NAT to grant the higher security interfaces to talk with the lower and ...

I have a 515 w/ failover units that I need to copy the configs from and put onto a 525 w/ failover unit. The 515 are running ver 6.1 ios and the 525 are running 6.22 ios. I copies and pasted from a text file, the 515 config and pasted to the 525 but ...

Hi allIs it possible to execute a script in aPIX 515 to initiate an action event?RegChamp

Hi,Has anyone tried to configure PIX IPSEC 56 to work with CyberGuard FireStar5 IPSEC 56 before ?Regards,Toh CS

I have a 515e working fine at one location, but my 501 at a different location will not pass traffic through.I have a DSL modem connected to the 501 on the outside interface, vpdn is authenticating to it over pppoe. I can ping the outside world from ...