Network Security

I have a PIX501 configured with static command to provide access from outside to an internal server. This works flawlessly, nevertheless as soon as I applied the static command my internal network can not browse the Internet all of a sudden! Any idea...

I keep getting this error on boot up of my pix 501 and don't know what it means."Error: can not add name attributeType help or '?' for a list of available commands." Any ideas?

Hi all!I have configured a PIX with two outside interfacesnameif ethernet0 outside security0nameif ethernet2 outside2 security0On one interface the network 172.16.1.0/24, on the other the network 172.16.2.0/24 can be reached. The PIX can communicate ...

Hi all!If I use two firewalls in redundant configuration and the PIX terminates IPSec, do the active and standby PIX replicate IPSec and IKE session information (spi number, actual DES key, packet sequence, ...) or in case of the active PIX fails doe...

Can I use VPN Manager for VPN management of Cisco 2621 ?It is any limitation of using VPN Manager?Thanks very much

Does the newest IOS allow IPSEC to pass-thru?? Here is my situation. I have have a 2514 with many internal addresses overloaded to one public address and Cisco VPN client doesn't work many to one translation. What is my best bet??

hithe problem: CiscoWorks 2000 could not be able to discover the 2620XM and 1751!!! and it show the map with a "?" with device type (ciscoProducts.468 for 2620XM and ciscoProducts.326 for 1751)PLZ any one have iea about this ... Thankx

Have a PIX 501 that is moving, via nat, traffic from the inside to the outside interface with no issues (ISP on the outside interface). The problem that I have run into is this, residing within the lan on the inside interface is another network via...

Hi all,I have 2 questions to ask, the first is if I use PIX with redundancy feature, Do the two PIX have the same IP on all of the interfaces? The second is, if I use two PIX without redundancy feature (two PIXs have their own IP) in the centeral sit...

Greetings,Greetings,We currently have only one outside interface on our corporate (head office) PIX. We’re planning on adding an interface for incoming traffic and a separate one for outgoing. I would like to force all IP traffic from our remote of...

Hello,Is there a workaround with regards to being unable to SSH to the secondary pix firewall once having failed over?Thanks,Paul--

It looks like the PIX accepts a standard PCI expansion card, but I was wondering if any one knew for sure that a third-party 10/100 Ethernet adapter would work.Thanks,Frank

What happens when your PIX uses 100% of its memory, will the PIX stop accepting connections and appear "locked up"? My PIX runs with an average of 12MB of free memory and recently it locked up for no apparent reason. It is a 515-R running v6.2(2), th...