Network Security

I play for the first time with a PIXand prefer to make a step by step progression.I have a config almost running but I would like to be able to reset the test config to be sure not to let dirty things in the config which will be in production.I see n...

On Pix Version 5.3(1). Can you configure the PIX to failover back to the Active after the Standby has become active and the fault on the original active has been fixed.

During the upgrade my running config file was overwritten with an earlier version. I had to correct some statements.If I do a "sh flash: I see:file 0:origin:0 length 1597496file 1:origin1597952:length:6447file 2:origin:0 length: 0file 3:origin:209664...

i need to install pix firewall manager 4.2(3)g on my windows 2000 server sp1 and i receive the following error:this program requires windows nt 4.0 or higher, terminating installation...i receive the same error when installing pix syslog server 5.1(1...

I saw the conduit command only in examples to limit the access coming from outside. Is it possible to give a (TCP/UDP-) port range for the users coming from inside? For example I want that the inside users can only reach Port 80 into the DMZ.

I have a pix firewall 520 with IOS version 4.2.1

Earlier versions of PIX Firewall software support only 2 network interfaces in PIX-515-R. From which version does the software support three interfaces?

Can the PIX be configured to perform security checks but not NAT?

If access lists are disabled on the PIX Firewall, does that mean all traffic is blocked?

The PIX currently is running PIX Firewall Software version 5.1, and I need to upgrade it to version 5.3.

I am running PIX Firewall Software version 5.0.3. For example, can I do:<pre>nat pool 172.30.0.0 255.255.0.0 </pre>but exclude: <pre>172.30.16.0 255.255.255.0</pre>

I want to upgrade my PIX515-UR from IOS Version 5.2 to 6.1Do I need a new 3DES license, or will the existing one work with the new IOS version?Wolfgang

I want to stop traffic for one ip address explicitily.I used :conduit deny tcp host my_ip host outside_ip eq 80 anybut it didn't work.What else can I try?

My problem is a static connection from the PIX to the ISP after configuring PPPoE with VPDN on the PIX. I can Ping the ISP DNS Server from the PIX and from the User, too -- but the connection never ends.What configuration parameter do I have to use, ...

Well, My PIX501 just come in the mail today. I first read all the documents that came with it, but nothing mention about the 3des license that is included in my purchase. The box said that the 3des key is included, but I dont see it anywhere. I bough...