Network Security

Dear all,I have failover 515 Pix, the logging configure as follows:[logging onlogging standbylogging buffered debugginglogging trap debugginglogging host inside 210.177.52.33]in pix menu, if logging standby will created doubles the amount of traffic ...

When using the "fixup protocol SMTP 25" command you tell the PIX to just accept standard SMTP-commands.Now when many uses ESMTP, would it not be possible to integrate support for this in the pix (i.e fixup protocol ESMTP 25) ?Do anyone know if Cisco ...

I have a old PIX 515 with 4.4 Software Image that I would like to keep before I upgrade the PIX IOS on it. Can you backup the image file?Thanks for your time.Nick

What methods are people using to automatically backup PIX configs? I'm putting together a script to SSH to the PIX and issue a 'write net' to a predefined tftp server. However, this is difficult and there are some issues in doing this.What are others...

Hi All,I have a client wants to create Real server On W2k server behind Pix firewall and I am trying to make the outside real player to contact the inside server but I failed..Is there any extra commands more than the following commands on the PIX to...

I am in need of information pertaining setup of DMZ on PIX 515. Currently we have a Web Server on a single ethernet interface. We need to add a second web server in a DMZ. My question is: Do I have to install a second ethernet interface for the secon...

Hi,I have upgraded the PIX 525 from version 5.3(2) to version 6.2(2). The upgrade was successfull but I have noticed that the commandisakmp identity hostname was no longer in the config in 6.2(2). Correct me if I am wrong, I do not think the command ...

After upgrading from 515 PIX to 515E PIX what would you recommend as the best tools available for testing the success of the installation on which the expected performance are better or a least the same as it was before the upgrade?

Can anyone tell me how this pix works with the 10 or 50 user limits? Does it learn the mac/ip address and only allow the first 10 through? If so then what is the time-out for the clients after they disconnect? and is there a way to change this?Can it...

Hello,I'm trying to use two PIX 525s in a failover configuration. But failover box is always in the "failed" state. There's no problem with physical connections (both ethernet and failover ). I'm restarting the fdailover box, issuying "failover reset...

Hello,we use PIX firewall 6.2(1) in a two stage firewall environment.Inside firewall is the PIX, outside firewall is a RAPTOR, because internet and e-commerce is more and more important, we are planning to build up a secondary outside firewall for re...

I need to reset my pass and enable pass on my PIX...do I have to go through password recovery? Can I change the pass through a set of commands?

Hello,I would like to know if there is any description of the IDS signatures on the PIX.I have looked at the dokumentation for PIX but there you have descriptions for all messages except the IDS.

Sres. Help Line, ELs comento que nos ha llegado la siguiente consulta para la cual precisariamos una mano:El cliente ccuenta con un esquema de VPN con un Csico 3000 vpn concentrator. Esta analizando migrar a un pix par aprovechar sus funciones de FW ...

Hi, Is there any way to monitor the state of a VPN (i.e. up/down) using SNMP? which MIBS/traps should I use? Note: we are using a PIX 535 as a terminating point for all the VPNs.Thanks in advance