Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Resolved! Access list

 object network SSL-VPN-POOL subnet 10.25.235.0 255.255.255.0object-group service DM_INLINE_SERVICE service-object icmp echo service-object icmp echo-reply service-object tcp destination eq https service-object object vnc object network iDRAC_LAN sub...

WiLL-I-Am by • Level 2
  • 2381 Views
  • 3 replies
  • 0 Helpful votes

Hello gentlemen, Sires, I am configuring a Stealthwatch enterprise, I did install Flow Collector and SMC, as well as I have confirmed the flow of netflow between one of the switches and the appliances, however I still have a doubt about the configura...

felipefom by • Frequent Visitor
  • 3766 Views
  • 6 replies
  • 0 Helpful votes

Hi,I am trying to ping webserver in dmz from a remote pc, with IP address 192.168.10.12 in packet-tracer. ASA drops icmp reply packet with message 'next-hop ip address is not in the ARP table'. I am able to ping the webserver from pc with IP address ...

Hi there,i am new to cisco environment, can anyone tell me how to configure the AnyConnect VPN in Cisco ASDM, i have ASA Version 8.4(3) and ASDM Version 6.4(7). i have tried to do it through AnyConnect wizard, but i am stuck on license configuration....

Cash2106 by • Level 3
  • 4828 Views
  • 17 replies
  • 0 Helpful votes

hi,there was a recent security scan on our anyconnect VPN headend and would like to "harden" the ASA FW.for the SSL DH group, i would need to change it to 2048 bits but there are 2 options presented: group 14 (224-bit) and group 24 (256-bit). which i...

#1 When I set up the router initially, I purposely turned on management via internet.. so when I access my static IP via internet to port 80, I get a login prompt to the router. How can I disable this over WAN? #2 How can I port forward tcp 5000 port...

ZDitner62005 by • Community Member
  • 3530 Views
  • 9 replies
  • 0 Helpful votes

Hi, I am wondering if I can upgrade my 1120 and 2110 appliances directly to the minor revision of 6.6 or do I have to upgrade from 6.4.x to 6.6, then 6.6 to 6.6.1? The upgrade matrix isn't clear if this is supported or not. If trying to do an upgrade...

ryan14 by • Level 5
  • 4982 Views
  • 7 replies
  • 0 Helpful votes

Hi All, I'm looking to configure a pair of Cisco Firepower 4110 appliances that are running ASA software. I have read through the below configuration guide and it states that when configuring the logical ASA device, a management interface needs to be...

dm2020 by • Level 5
  • 3334 Views
  • 4 replies
  • 0 Helpful votes