Hello. I've done a search for a problem such as mine but haven' been successful. I have three interfaces, Inside, Outside, and DMZ. I have already setup Inside to Outside and Inside to DMZ nat and ACLS. I however cannot get Outside to DMZ working cor...
Forum Posts
Hi all, is there a way to block incoming traffic from known VPN providers? I see that URL filtering has a Proxy avoid and Anonymizers category that I could use in an ACP rule, but would that work for incoming traffic?
Hello, I have a problem in my ASAs (active-standby), Why did both of my ASAs have the same new uptime but the cluster uptime remain unchanged? If there are some information you need, i will try to share it thank you so much
Hi All,I have the below config in ASA for diverting traffic to IPS module.But still im unable to block as well as not able to see torrentz traffic in IDM logs, by checking on IDM logs and "show event past 00:00:10".access-list ips_acl_1 extended perm...
Hello everybodyAfter adding a new interface in a Firepower, the FMC reports in the Health Status the warning: Interface Status (Associated Port-channel 1.10)The interface is configured and running properly. How do I get the message in the Helth Statu...
I am trying to use the command "change-password" to change the password.But there is a ERROR: Invalid username and ERROR:Password not changed Is there any one able to use the command to change the password?
I am going throug the CCNP SEC. Just got the two thing in my front. Can anybody pls specify the work and difference between AIP SSM and CSC SSM.Thanks in advance.
dear all i need your help in below points which an issue i spent couple of hours but i cant resolve so i need to get some help from your great and valued information : 1- i cant enter to enable or exec mode ( before i can but maybe after changed the...
Hello Team,From an external jumbhost server user's are trying to connect our network via Cisco Anyconnect. But only one user on the jumbhost server can connect to anyconnect VPN other users connected the same server via RDP are not able to connect th...
Resolved! How to retrieve activation-key
Hello, I have erased my asa 5510 flash and forgot to write down the activation key. How do I now retrieve my activation keys??? Kind regards, Gary Lefebvre
Dears, I have a firewall with software source fire. license : ips + application + url filtering i blocked everything related to facebook , youtube , some vpn ,etc... and all is okey. There is an application ( PSIPHON) that users install it on their m...
Hello everyone,I wanted to white list the range of ip addresses, a few blocks, some /25 and some /26.In security intelligence - network list and feeds I have white list list/feed where I add specific IP that I want to white list (download list, updat...
This topic is a chance to clarify your questions about the best practices and required elements to migrate your Cisco Adaptive Security Appliance (ASA) to Firepower Threat Defense (FTD). Because of the continuous evolution of cybersecurity threats, i...
Hello Folks, I am having an issue were I am unable to access the 10.10.50.0/24 network when I am behind the 192.168.1.0 network. I have built a NAT statement for when I am accessing the 192.168.1.0 from the 10.10.50.0/24. However, when I try and acc...
Hi. I have an FTDv (6.2.2.81) and an ASA 5515-x FTD (same version) in my lab. On FMC both devices stuck on "Deployment" phase and I cannot cancel it. I managed to stop the ASA FTD and restart the FMC and now it shows "Failed in Deployment" but cannot...
