Do we have any command to list out the high-performance snort rules the way we have for low performance? Also commands for what all protocols are consuming the high performance.
Forum Posts
I have ASA 5525X, on my NMS showing high utilization of mempool_global_shared as shown in the attachment. Is it normal, any reference link from Cisco as not to monitor this object?
I have a application behind Cisco ASA & the application uses UDP.The client connects to the application using UDP port & there is 2 ASA firewall between the client & the application server. ASA 1 does the source NATASA 2 does the destination NAT Let ...
Hello, I have created a VLAN and I want limited traffic going between the VLAN and my inside interface. I have traffic moving from the VLAN to the 2 IPs on the inside. However I cannot access the VLAN from the inside interface. Here is my config. Can...
Hi Experts,We've ASA with Sourcefire module installed and I've queries on Network Discovery. Please excuse my lack of skills on Sourcefire as i'm new to this. On going through the videos, noticed Network Discovery is the initial step is learning the ...
I have FTD virtual 6.4 managed locally ( FDM ) , does it support anyconnect if I want to get a temporary license to test ?
Resolved! Reduced number of AnyConnect sessions
Hi, We purchased a pair of ASAv50 for a failover setup. I noticed that the number of AnyConnect sessions is reduced to 750 even if we have enough licenses and the platform is supposed to support up to 10000. Why does this happen? License mode: Smart ...
We have a newly deployed FMC 2500 hardware appliance that we are staging in preparation to be added to our production network....it was authenticating via RADIUS to our ISE VM node....our ISE node crashed and has to be completely rebuilt and in the ...
Hi,I have ASA 5525-x and i wanted to use the IPS Software module (Whichi never used it before). Can you please help me to configure the IPS Module.Below is the output of Sh Module IPS
I've setup a new FirePower 2130 and I want to monitor the interface usage of it. I'm using Eth1/1-Eth1/4 of the device and they are configured and up Interface: Port Name Port Type Admin State Oper State State Reason -------------- ------------------...
Resolved! FMC not booting
Hi experts I have an issue with FMC.Its not coming up.Attached screen shots.Please Help
Resolved! ASA 5516-x ASDM don't connect firepower.
Hello.My ASA 5516-x don't connect firepower.I launched asdm, asdm is stucked "software completed" about 1-2 mins.after 1-2mins, asdm boot up, but I can't see firepower panels.and I clicked "ASA firepower Status", ASDM is stucked constantly, so i need...
I am trying to change the syslog port number from udp/514 to udp/5141. However when I look at the traffic it appears to still be sent on udp/514 logging enablelogging trap informationallogging asdm debugginglogging host inside 192.168.55.225 17/5141
Resolved! Accessing ASDM from Anyconnect VPN
hi,i want to access the asdm when connecting through any connect vpn, when i connect through anyconnect, i get an ip from a pool of 172.50.50.0,i added this to my ASA config:http 172.50.50.0 255.255.255.0 Insidebut still i cant access the asdm, is th...
Hi Experts,I'm migrating 5525-X HA to 5555-X HA.Due to logistics, I've migrated Secondary first. I now need to bring Primary into HA.I need to ensure that new Primary syncs from Secondary, and not the other way around.Would the best way to ensure thi...
