Hello,I have come across the below document:https://www.cisco.com/c/en/us/support/docs/security/firepower-management-center/212700-configuration-and-operation-of-ftd-prefi.html In task 2, It was mentioned that the icmp reply was blocked and the clish...
From the FMC - I have created an Access Control Policy and within that Policy I have a simple "any to any" rule. Within my "any to any" rule - I have my own Intrusion Policy set and also my own File Policy.under the inspection tab. Within the Acces...
Hello, I am suffering against arp attacks into my Lan (Netcut - selfishnet). What configuration i must do in my CISCO SWITCH 2960 to stop this
Hello We are replacing our existing ASA 5520s with ASA 2210s and would like a sanity check on the configuration we'll be putting on them. Here is the proposed active unit configuration (without ACLs, NAT or S2S VPN at this point): ASA Version 9.8...
Hi Im Pretty sure this is not possible but would like to know if it is possible to use a Cisco ASA 5516-x with Dual Wan.ISP would be Say Virgin media and Talk Talk and do Full Load Balancing and WAN Failover both Internal and Externali know we cand s...
I've got, two 5515-X firewalls (in Active/Standby) and two remote sites with ASA5506-X firewalls (connected via site to site IPSEC VPN). I've deployed the FirePOWER Management Appliance (VMware) version 6.0.0.1 Build 26, I've updated the SFR modules...
Hello... I am trying to backup an FM4500 to my SCP Server. I can not get the backup to transfer. I am not using SolarWinds SCP Server and am unsure how / where to put SSH Public Key... See the screenshot.
Hello Experts,I have recently unpacked ASA 5525x that was procured few years back. I have mostly worked in Juniper based environment and new to Cisco firewalls. As per the officials working already in the department, the warranty of the ASA firewall ...
Dear Community Support,i have on question about APIC-EM ACL. Analysis tool.which two values are needed to run the APIC-EM ACL Analysis tool?is it destination address and source address.
After a disconnection occurred in a video conference, troubleshooting was initiated to identify the root cause. After log analysis, we found that the call was disconnected by H.323 timeout. However, I would like to know if you have any ASA parsing or...
If I am not wrong the group policies are mapped to the connection profiles (tunnel-groups) and they applied to the users based on the group they choose in the cisco any client software. So what happens to the group policies which are not part of any ...
Hi, I'm attempting to configure an ASA so that it can ping the internet. It is able to ping 8.8.8.8, but not google.com. I get an invalid hostname error instead. Here are the configs I have on the ASA. Can anyone help me figure out what is wrong ...
Hello I have some domains configured and firewalls added. I would like to move a firewall from, say, domain x to domain y, how can I do that? I read "https://www.cisco.com/c/en/us/td/docs/security/firepower/60/configuration/guide/fpmc-config-guide-v6...
Hi all,I think i have a simple question but can't find a solution for it yet.Consider the following topology:We have a IPsec tunnel between ASA1 and ASA2. The traffic through the tunnel is the AnyConnect Subnet (192.168.10.0/24) and the LAN behind AS...
I am trying to authenticate SSH connections via RADIUS, but I cannot get my ASA to connect to the RADIUS server (AD DC w/ NPS) despite the fact that the server is local to the inside interface. The ASA IP is 10.10.10.1 and the RADIUS server IP is 10...
