Network Security

HelloASA5508 with Cisco Adaptive Security Appliance Software Version 9.8(2) Currently all HTTPS traffic is assigned the firewall outside interface IP address. I have about 13 external IP addresses. How do I assign all outbound https traffic its own I...

I have an old 5505 and recently upgraded my internet from 75 to 100mbps but am only getting about 65mbps up and down. I spoke to the ISP, Verizon, who had me test the speed with my laptop connected directly to the Verizon equipment and I was getting ...

Clear XLATE break all current connections using NAT on the ASA?

Purchased an ASA5516 with FTD.  The ASA was re-imaged with ASA w/Firepower.  The license that was purchased with the ASA is a Smart FTD license.  We can't seem to get the smart license applied to the ASA now that it has been re-imaged.  I would think...

Hello.I cannot find option from Web to change default port Management HTTPS or Anyconnect.I manage FTD localy, not from FMC.If I enable HTTPS access on outside interface - SSLVPN stop working. Have you met with a similar problem?Is any option to chan...

Good evening everyone.The bug I referenced above is a high severity and I happen to have an old end of life ASA 5520 that shows on the "Products confirmed not vulnerable" list.  My general concern is that I ran the "show asp table socket | i SSL|DTLS...

Hi, I have a strange problem here. We have a site to site vpn from a branch office to our head office. In the branch office we use a Cisco ASA 5510 9.1 (3) and in the head office we use a Cisco ASA 5516 9.6 (1). We have some networks here which go tr...

I wanna configure  a static NAT rule , from outside network (internet)  to access  inside switch (intranet)using telnet protocol .  pls see below my setting ,but NAT didn't work , kindly advise right setting .inside switch IP : 192.168.101.211firepow...

ASA 5515 ver 9.4(4)36 is not handing out DHCP leases, only one interface is setup for DHCP dhcpd address 192.168.45.129-192.168.45.252 Guestdhcpd dns 8.8.8.8 8.8.4.4 interface Guestdhcpd lease 3000 interface Guestdhcpd enable Guest I have done no dhc...

Hi All, I currently would like to export all my object groups and access-lists to excel. In the access list I would like to get the access list name and interface as well. I do not want to copy/paste since it is difficult for a person who do not know...

We are doing a Meraki Migration in our Store it failed.While we are also checking on our Provider(AT&T),can you please make sure that the following ports in the current connection has no blocking point?  

Hi i am putting show environment command but not able to get there , i am new , one of friend suggested to change to context system , dont know how to do that. hope if someone can help here.He is using PRIFWPROD01/pri/act#  and is working for him , i...