03-14-2022 05:24 PM
Guys,
I am facing an issue in the N7K where I trying to configure the ip dhcp relay address X.X.X.X on a VLAN interface, but I getting the following error message:
ERROR: hardware programming failed. Reason: Tcam will be over used, please enable bank chaining and/or turn off atomic update. If bank-chaining is enabled on other modules and this is a new linecard insertion, please enable bank-chaining prior to reloading this module.
Thanks!
Solved! Go to Solution.
03-14-2022 05:52 PM
03-14-2022 05:52 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide