Hi,I'm setting up a guest ACL on a Cisco 150ax for the Guest WLAN.As I simply wish this to be a second (Guest) WLAN to the primary business LAN (using WPA2/WPA3 credentials) I need to lock down access to other business devices etc and are looking to ...
Every few seconds CBD 2.10.1.20250728 runs a job called "Delete offline devices". First up, running this often is beyond ridiculous. Second, there could be obvious reason why devices may be offline and we don't want them deleted. When I look at sched...
Hello, I've successfully set up a CBD VM and added a C1200 L3 switch to be directly managed by it. I also have two Catalyst 2960 L2 switches which cannot by managed by CBD, but I was still wondering if I can at least see them in network topology sinc...
I'm currently checking IOS 16.12.14 for upgrade advice on the Cisco Software Checker. I found a message stating, "Contact your support organization for upgrade instructions." I would like to know: does this mean that the version I'm checking is the l...
I have a small office network with an existing CBW150AX-E-EU AP. I'm trying to add another CBW150AX-B-NA AP to the same network. It is a single VLAN network with a switch and an ISP router with DHCP service.The new AP powers up and boots to a conditi...
Greetings,We have a Cisco RVS4000 working perfectly. We also have 2 spares -- one used and one new.We ended up with a spare AC adapter from another manufacturer: it's rated at 12V and 1.5A .The original AC adapter that came with the RVS4000 is rate...
Kindly check and update this serialnuber warranty - F0C2638Y4LC
Is there any possible way to configure retention policy in Cisco FMC for cisco FMC and FTD backups. The FMC version is 7.6.1
Welcome to the Unified Communications 500 (UC500) Software Download page. This page contains the most recent software for UC500 Series platform.UC500 Software PacksThe UC500 Software Packs contains large zip files with all necessary files for the UC5...
I am trying to get our CISCO RV345 Router working with a NBN modem in bridge mode.1: We have a FTTN NBN connection with a a static IP address. It is an IPoe type connection.2: We are using a DrayTek167 as the NBN modem and it is in bridge mode.3: Eth...
Dear All,I purchased a switch with PoE and a DHCP server for an intranet.However, I am unable to get the latter to work.Please see the attached file for the fields I have modified.What did I forget to configure, or what did I configure incorrectly?Co...
I have a working CBD. Now I try to connect to it from my iPhone (IOS 26.0.1) with Cisco Business App (1.12.0). In the app I choose "Cisco Business Dashboard Site", type a name and scan a QR code displayed on the CBD screen. The error "Unable to estab...
SNMP is turned off. FW update does not help- we've tried the latest 2.0.2.15using ethernet ports at 100% CPU is no good. We were able to use the console port to verify the 100%only a power cycle brought the CPU usage back down to normal levels.
Hi,I'm trying to do a factory reset using the button on the device. Although the lights cycle like advertised, it doesn't appear to have reset (i.e. getting itself an IP address from my DHCP server).Any suggestions would be nice.Thanks!Best,Michiel
