10-31-2006 05:58 AM - edited 03-13-2019 03:36 PM
I am trying to configure a 2621 (non-xm) with the following config..
Non-IP PBX (PRI Interface) -> VWIC-1MFT-T1 -> SIP -> Asterisk -> PSTN
I can see the calls reaching the 2621, but they never leave the 2621 to go to the Asterisk. I see the calls via
"sh isdn history".
Based on this the non-IP pbx is talking to the 2621.
Does anyone have any suggestions?
All outbound calls from the non-IP PBX will go to the 2621. All inbound will come from the pstn-> asterisk -> 2621 -> non-IP PBX.
I am under fire to show proof of concept in the next 24 hours..
10-31-2006 06:03 AM
if you see the calls get to the 2621 but are not forwarded to the Asterisk, you may have a dialPeer issue.
verify your outbound dialPeer(s) are correctly configured to forward the calls to the Asterisk system.
please see the following links for more dialPeer info:
understanding dialPeer inbound/outbound:
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080147524.shtml
understanding dialPeer matching:
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml
understanding the operational status of dialPeers:
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010e6d1.shtml
if you need further assistance, please paste your configuration, minus sensative ip addys and we can help you.
10-31-2006 06:28 AM
I have looked thru them and also some of the configs on the net. I haven't been able to find the right commands to get it to connect over SIP. I haven't seen an example that matches my type of configuration.
Any examples would be appreciated. Thanks
10-31-2006 06:54 AM
Is there a way to place a call over SIP from the cisco CLI?
I know I can over the PRI using
"isdn call int serial1/0:1 123-456-7890"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide