2620 XM MGCP Configuration for Megacom Service????

[d.gavin]

I am having some difficulty getting a PRI configured properly on a 2620 with an AT&T Megacom facility.

Inbound calling is fine but we are receiving "Information Element" errors on outbound calls.

We are running MGCP on this gateway. Does someone have a working config for MGCP and Megacom on a 2620 XM?

Thanks,

Dan

[mcotrone]

Can you post your debug isdn q931, sh mgcp, and mgcp config?

Thanks

Mike

[jocoates]

Was there a resolution to this issue? We are hitting the same problem.

Inbound fine, however outbound is failing with same error message.

Cheers

John

[mcotrone]

What is your called party IE number type, calling Party IE number type, Called Number Plan, and Calling Number Plan?

Depending what you are seeing on your Q931 events I have succsssfully used:

Called Party IE number type: National

Calling Party IE Number type: Cisco

Called Number Plan: ISDN

Calling Number Plan: Cisco

Again I tuned this using my ISDN Q931 debugs.

HTH<

Mike

[mcotrone]

Again this is for an ISDN Switch running NI2 protocol emulation...