We just installed Cisco UC 9.1.2.10000-28 and we are having an issue getting our Bogen Paging System to work with it. We have a standard FXO port setup as Loop Start. This cable goes into a Bogen DFT-120 which records the page and then sends it to the PCM-TIM and out through the amp to the spearkers in our plant.
when we plug a plain old analog phone into the DFT-120 it works fine. When I plug the cable from the FXO into the system, I can see the device record and send through but not out the speakers. When I put my toner on it the sound comes through but very low from the DFT to the TIM. I have the volume turned all the way up on the DFT.
Any ideas on how to fix this?
