07-17-2008 10:05 AM - edited 03-13-2019 05:28 PM
we have CM 5.1 with 2811 mgcp gateway running isdn qsig to Avaya s8700. Caller id name is not passing between Avaya & Cisco in both direction.
07-17-2008 12:28 PM
There should be a setting in CM regarding qsig version, try changing that.
07-17-2008 03:50 PM
well the encoding needs to BE ISO, if its ROSE I don't think CM will give you calling name..
Chad
07-22-2008 04:40 AM
Hi,
Here's the integration doc for CCM 6.0 and S8700, where it states that CLID works.
Have a look at the configuration -
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/607577nt.pdf
You might be required to tweak so setting on avaya side.
-> Sushil
07-22-2008 09:30 AM
Thanks for all your reply,
I found that we have Avaya Definity System with S8700 & found configuration documentation :
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/410364av.pdf
What I found that Avaya side is configured for Qsig ; Basic Supplementary Services is not enabled (System Parameter & Customer options) .
I also found this document ( http://www.svcc.cc.il.us/UserMenu/employees/telephone/images/buttons.pdf Page 362) about Supplementary Service protocol value which most likely change which Qsig Avaya side use.
Once again thank you all , will let you know if things work .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide