CCM 4.x - Nortel PBX Integration Setup

[jmujica]

I have a customer where the Nortel PBX doesn't have support for either Q.SIG and PRI at the moment. So we will have to go with E&M Wink Start on a T1 circuit.

Will that be a problem running MGCP between the Gateway and CCM 4.x?

I'll aprecciate any inputs.

-Jose

[8r-schumann]

You should be fine with that setup.

[jmujica]

Thanks for the quick response. I add the Gateway as an MGCP and choose T1-CAS. On the gateway I add the

ds0-group 1 timeslots 1-24 type e&m-wink-start dtmf dnis

but the CCM removed that command from the Controller? Is that right? I put back the command because without that command the router would not add the T1 Voice-Port.

-Jose