01-07-2005 05:58 AM - edited 03-13-2019 07:33 AM
Dear All,
I have two voice gateway (GW1 and GW2) and each voice gateway has a PSTN circuit.
In the callmanager, I configured the route group with GW1 first and then GW2.
Is all outgoing call use GW1 first and then use GW2 when GW1 is all busy? or is the outgoing call load-sharing between GW1 and GW2 (in what ratio, 1 to 1 or any)?
Thanks.
C.K.
01-07-2005 08:18 AM
Both route lists and route groups are prioritised lists.
So if you have a route list, with two route groups in it, calls will go to route group 1 until all lines are busy or the gateway fails, then will go to route group 2.
The gateways you add to a route group are also prioritised, so calls will go to the first line/gateway in the route group, then the second if the first fails or is busy...
You can change the route group behaviour so that it will load-share if you want. To do this add each GW to the route group but set the order to 1 on each.
Then go into service parameters and set ReorderRouteList to True.
Hope this helps
Aaron
ps Please rate my post.
01-09-2005 06:17 PM
Hi,
I cannot find the service paramters - setReorderRouteList. Where can I find this parameter and modify it.
Thanks.
C.K.
01-10-2005 04:21 AM
Go to CCmadmin, then to Service/Service Parameters...
Click on your CM server, then the Cisco CallManager service.
On the page that appears ReorderRouteList will be in the section titled 'Clusterwide Parameters (Route Plan)'. You could just use the Find feature under the edit menu in IE to find it by searching for reorder...
Regards
Aaron
Please rate my post...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide