Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I used vpn client to connect to PIX firewall.vpngroup abc idle-time 1800After I connect to PIX and do not have any traffic for more that a hour, the vpn connection did not disconnect.Is the idle-time use to disconnect the vpn connection afte...
Dear All,My core switch is 4500 which support Private Vlan. However, I have several closet switch (2950) which only support Switchport Protected. 4500 and each 2950 are connected with trunk using fiber.How can I config PC at 2950_Switch1 cannot commu...
Dear All,I have use a Cisco Router for a CA Server. The Certificate of this CA Server is Expired. So all other router that enroll to this CA Router is expired.How can I re-create the CA Certificate so other router can re-enroll to this CA router?Than...
Yes, the user is part of the group.My config is similar except "Configuration > User Management > Groups; under the IPSec Tab, when I config the authentication to Internal, the connection failed. When I use None, the connection is ok without user log...
Yes, on my hosts and lmhosts file,10.1.1.1 ccm110.1.1.2 ccm2I can access to ccm2 using http://ccm2/CCMAdmin or http://10.1.1.2/CCMAdmin but for ccm1, only http://10.1.1.1/CCMAdmin and cannot access http://ccm1/CCMAdminAlso, when ping ccm1, the result...
I have used a straight throught RJ-11 cable connected between the two router. But the ATM interface is down, line protocol down.What is the config requried for the atm interface? Would you provide some sample config?Thanks a lot.Chan
