04-01-2004 01:28 AM - edited 03-13-2019 04:30 AM
Hi, I was wondering if it was possible to set an interval of less than 30 seconds. If that's not possible, does anyone know how to get the same data another way?
Solved! Go to Solution.
04-01-2004 03:32 AM
Hi,
As per the CRS-3.1 release notes...
The following data writing intervals have been added: 5, 10, 15, 20, and 25.
You can set the data writing intervals from Cisco CRA Administration by choosing Tools > Real Time Snapshot Config and then choosing the desired
value from the Data Writing drop-down list. These new data writing intervals are useful when wallboard data is required to be updated with a refresh
interval of less than 30 seconds.
Regards
Yogi
04-01-2004 03:41 AM
Hi,
One method of retrieving the realtime data is to write an http triggered application that uses the Get Reporting Statistics steps to obtain the desired info and present it back to a browser.
Regards
Yogi
04-01-2004 04:11 AM
Hi,
Check out the CRA Editor Step reference guide. The URL for the same is as follows
For 3.5
http://www.cisco.com/univercd/cc/td/doc/product/voice/sw_ap_to/apps_3_5/english/admn_app/step.pdf
Regards
Yogi
04-01-2004 03:32 AM
Hi,
As per the CRS-3.1 release notes...
The following data writing intervals have been added: 5, 10, 15, 20, and 25.
You can set the data writing intervals from Cisco CRA Administration by choosing Tools > Real Time Snapshot Config and then choosing the desired
value from the Data Writing drop-down list. These new data writing intervals are useful when wallboard data is required to be updated with a refresh
interval of less than 30 seconds.
Regards
Yogi
04-01-2004 03:41 AM
Hi,
One method of retrieving the realtime data is to write an http triggered application that uses the Get Reporting Statistics steps to obtain the desired info and present it back to a browser.
Regards
Yogi
04-01-2004 03:51 AM
Hi,
Thanks for the info yogi. Can you post a link or tell me which document to look for to get more info on the Get Reporting Statistics steps?
Thanks
Pete
04-01-2004 04:11 AM
Hi,
Check out the CRA Editor Step reference guide. The URL for the same is as follows
For 3.5
http://www.cisco.com/univercd/cc/td/doc/product/voice/sw_ap_to/apps_3_5/english/admn_app/step.pdf
Regards
Yogi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide