10-22-2001 07:45 AM - edited 03-12-2019 12:58 PM
Hi,
I'm using a cisco 1751 as voice gateway with voice BRI but the IOS version that I mounted 12.2(4)T does not support the compand-type voice port configuration command needed to set the voice port as european port.
Does anyone know if it is a workaround for this?
Thanks,
10-22-2001 07:48 AM
Actually, all you should need to do to set it to Italian for example is configure this command in the voice-ports - cptone it
10-22-2001 07:54 AM
Yes I already put this command but the call not start.
10-22-2001 08:13 AM
Can you turn on debug isdn q931 before you make the call, turn it off after the call fails, and paste the output of the debug here?
10-22-2001 08:29 AM
Here is the debug...
00:31:15: %LINK-3-UPDOWN: Interface BRI1/1, changed state to up
00:31:15: %ISDN-6-LAYER2UP: Layer 2 for Interface BR1/1, TEI 94 changed to up
00:31:15: ISDN BR1/1: TX -> SETUP pd = 8 callref = 0x05
00:31:15: Bearer Capability i = 0x8090A2
00:31:15: Channel ID i = 0x83
00:31:15: Display i = 'Nicola', 0x20, 'Morelli'
00:31:15: Calling Party Number i = 0x00, 0x80, '326', Plan:Unknown, Type:Unknown
00:31:15: Called Party Number i = 0x80, '0644252911', Plan:Unknown, Type:Unknown
00:31:15: Sending Complete
00:31:15: ISDN BR1/1: RX <- CALL_PROC pd = 8 callref = 0x85
00:31:15: Channel ID i = 0x8A
00:31:19: ISDN BR1/1: RX <- DISCONNECT pd = 8 callref = 0x85
00:31:19: Cause i = 0x80D8 - Incompatible destination
00:31:19: Progress Ind i = 0x8288 - In-band info or appropriate now available
00:31:19: ISDN BR1/1: TX -> RELEASE pd = 8 callref = 0x05
00:31:19: ISDN BR1/1: RX <- RELEASE_COMP pd = 8 callref = 0x85
10-23-2001 02:02 PM
CSCdv00152
A Cisco 2600 or 3600 series router that is running Cisco IOS Release 12.2(3) does not support the compand-type a-law command in voice-port configuration mode on the Command Line Interface (CLI) for a Basic Rate Interface (BRI) port. Therefore, it is not possible to configure the Cisco 2600 or 3600 series router to work with Integrated Services Digital Network (ISDN) BRI port with a-law. There is no workaround.
I would go down to 12.1(5)T9 or if you want to go up it should be fixed in 12.2(5)T
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide