Hello, my router boots as shown below but after that it can not accept any keyboard in put.
Help its urgent
System Bootstrap, Version 12.2(10r)1, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2002 by cisco Systems, Inc.
C2600 platform with 49152 Kbytes of main memory
program load complete, entry point: 0x80008000, size: 0x5aa9ec
Self decompressing the image : #################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
000094 0X000BA600 C2600 Single Fast Ethernet
0X000F3BB0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X003BF1B0
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 4Mb.
Using 8 percent iomem. [4Mb/48Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-D-M), Version 12.2(7c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 10-May-02 22:03 by pwade
Image text-base: 0x80008088, data-base: 0x80AD673C
cisco 2620 (MPC860) processor (revision 0x00) with 45056K/4096K bytes of memory.
Processor board ID JAD07020GEC (4193236349)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
