cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1567
Views
0
Helpful
1
Replies
Highlighted
Beginner

Configuring SIP Trunk in CUCM

Hi

We have configured  SIP Trunk recently and have problem while creating inbound call from PSTN. We have used the command "debug voip dialpeer detail " inorder to make sure that our dial-peers function fine. I think my configurations from vgw-CUCM is not correct. I have attached the SIP Trunk configuration and want to make sure that it is configured correctly.

Thank You

SIP Trunk.jpgSIP Trunk2.jpgSIP Trunk 3.jpg

 

 

1 REPLY 1
Highlighted
Hall of Fame Cisco Employee

Most of the configuration is going to depend on your CUCM config/call routing/dial plan, without knowing that, there is no way to tell you if something's wrong, you should be able to tell as you know the rest of the config.

I suggest you use DNA to test some calls as if they were coming from that SIP trunk, and see if your call routing is correct.

I see you use the <none> CSS for inbound calls, that might be a problem, but that depends on your CSS/partitions configuration, and what you're dialing.

HTH

java

if this helps, please rate
Content for Community-Ad