cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
706
Views
0
Helpful
8
Replies

Could anyone give help me in installing dmm 5.3 in UCS -SERIES SERVER

I am trying

to install DMM-5.3.0.244.isov in the UCS  B-series  server

i am getting the below error

Could anyone help.

Please give me the alias for DMM.

2 Accepted Solutions

Accepted Solutions

So I do have the same iso image you are trying to use.  I think you may have an incorrect hardware configuration on your C210.  Is it an off the shelf C210 or was it purchased as a DMM?  I'm pretty sure DMM is only supported on a C210 that has hardware specd specifically for the DMM.  Basically it is an appliance. 

Cisco Digital Media Manager 5.3.x on UCS C210 (DMM-SVR-C210-K9)

I don't think I can't help you from here.  You will have to contact TAC.

View solution in original post

8 Replies 8

Mike Assel
Enthusiast
Enthusiast

DMM is not supported on the B series.

Hi Mike,

I have also tried with the c-series server, am getting the same error.

Please help.


Can you give alias for DMM.

http://www.cisco.com/en/US/partner/docs/video/digital_media_systems/5_x/5_3/dms/aai/administration/guide/intro.html

Supported Appliances

This document describes how to set up and administer the following Cisco Digital Media System (DMS) 5.2.x appliances:

Cisco Show and Share appliances:

Cisco Show and Share 5.3.x on MCS 7835-H3

Cisco Show and Share 5.3.x on WAVE-574

Cisco Show and Share 5.3.x on UCS C210 (SNS-SVR-C210EN-K9)

Cisco Show and Share 5.3.x and Cisco Show and Share Reports 5.2.2 on UCS C200 (SNS-SVR-C200WG-K9)

Cisco Digital Media Manager appliances:

Cisco Digital Media Manager 5.3.x on MCS 7835-H3

Cisco Digital Media Manager 5.3.x on UCS C210 (DMM-SVR-C210-K9)

Which C series?

C210 series i have installed but getitng error

Thanks a lot.

WHere did you get the iso you are using?  I'm not familiar with that version.  Is this a fresh install or an upgrade?  Normally you have to upgrade from 5.2 to get to 5.3.  You can't do a fresh 5.3 install unless you have a special iso that someone from Cisco posted to you.

So I do have the same iso image you are trying to use.  I think you may have an incorrect hardware configuration on your C210.  Is it an off the shelf C210 or was it purchased as a DMM?  I'm pretty sure DMM is only supported on a C210 that has hardware specd specifically for the DMM.  Basically it is an appliance. 

Cisco Digital Media Manager 5.3.x on UCS C210 (DMM-SVR-C210-K9)

I don't think I can't help you from here.  You will have to contact TAC.

i have 2 doubts still

1. i have only ucs server which is not purchased as dmm, can i try  with DMM 5.4 VM image whether it will work.

 

2.

I need to implement Digital signage solution in my office workplace.

I have DMP 4400G and TV only , can I implement the solution without DMM,SNS,Stadium vision director.


Please suggest me your valuable inputs

Thanks a lot for your great support.

Rajesh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers