01-11-2020 12:55 AM
what is the use "run on all active cm nodes " in sip trunk?
what will happen if u enable that ?
what is the behaviour if we disable that?
Solved! Go to Solution.
01-28-2020 05:53 AM
Hello,
if you have a deployment of a cluster (PUB & Sub) every time you create a trunk in the PUB and activate "run in all active nodes" this trunk applies to all cluster members(SUB) too.
Kalliopi
01-28-2020 12:44 PM
If you don't enable it, the trunk will only run on devices within the devices in the CUCM group.
If checked it will run on all active nodes with the cucm service enabled.
01-11-2020 06:32 AM
Please use descriptive titles for posts and not just "CUCM" every time you post to make it easier for people to know what you're asking. What you're asking has been discussed several times before at CSC, have you looked at those posts?
01-28-2020 05:53 AM
Hello,
if you have a deployment of a cluster (PUB & Sub) every time you create a trunk in the PUB and activate "run in all active nodes" this trunk applies to all cluster members(SUB) too.
Kalliopi
01-28-2020 12:44 PM
If you don't enable it, the trunk will only run on devices within the devices in the CUCM group.
If checked it will run on all active nodes with the cucm service enabled.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide