10-19-2006 08:36 AM - edited 03-13-2019 03:26 PM
I have a Cisco Media Module (CCM) gateway in a Cat6500 running 12.3(8)XY5. I'm trying to use the command "debug isdn q931" command but don't get any output when I make a call. I have one six port T1 module installed in the CMM card and I'm using ports 1/0:23, 1/1:23; 1/2:23 and 1:3:23.
I inputed the command as follows:
debug isdn q931
term monitor
Then when I make a call on that gateway I get no results.
I also tried this syntax:
debug isdn q931 interface serial1/2:23
term monitor
but I get no output when I make some test calls. What am I doing wrong?
Larry
10-19-2006 08:51 AM
Larry,
Can you try "logging console informational" and see if that helps. Do you have any logging turned on pointing to a syslog server ?
10-20-2006 11:16 AM
Shanky
I tried the "logging console informational" but that didn't help. We don't have logging turned on. Any further ideas that might help?
I also have a VG200 with a T1 and the command debug ISDN q931 works just fine there, just can't figure out why it won't work on the Cisco Media Modula.
Larry
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide