Hi,I have a customer who would like to restrict call forward only to local numbers with a Call Manager express, is this possible ? Thanks for your help,Fred
Need some assistance with the partial trace that's attached. Call comes in via PRI, CCM(4.0(2a)sr2b) to route call to gateway with T1CAS. From the trace i'm guessing that its failing with "B channel out of service". The controller shows up/up and ...
HelloI have installed MeetingPlace Express. So far I can access all the web pages and functions except I can not join and/or start a meetingWhen ever I click on Join meeting, I enter the username and password and/or login as a guest, I get this erro...
Is there any IOS command that i can use to trace a call? i mean if i make a call how would i come to know which extension the call has landedI am using CCME 3.2thanks in advance
Hi,I'm playing in the lab to integrate CallManager and Asterisk. I configured SIP trunk between systems. I defined a couple numbers in both systems. I have some overlapping numbers (the same phone number in both system), and individual numbers, uniqu...
I work for a large multinational company prsently in the initial rollout of VoIP.Locally call manager setup and clustering is good in terms of both quality and reliability. However as most of the staff are highly mobile between locations things get c...
Is there a VoIP network design guide for CCM 5.x? When I look at the available documentation on CCO I can only find reference network design guides for CCM 4.0 and 4.1?
Hi, I briefly describe my scenario. I have a voice gateway in which are linked some IP phones. Then this router is connected to a SIP proxy that forward the calls to an IP to IP Gateway wich converte the SIP in H323 protocol to transport voice to int...
On a IPCCX implementation, I got a request to use a frame-relay link to receive calls from a customer. The problem here is about codecs: IPCCX only supports only g.711 (reinstallation is needed to swap codecs) and the provider is delivering only g.72...
The IP office unit is in vlan 3 on a 3750 in office B. The 3750 is connected to another 3750 in office A, via a fibre loop. Three IP phones have been plugged into the 3750 in office A, and obviously need to connect to the IP office unit in office B. ...
We use the route pattern 9@ for outgoing calls and when dialing a local number with just 9 and the local number (9XXXXXXX), it takes a while for the number to go through. If we dial 9 and the area code-local number (9XXXXXXXXXX), the phone starts rin...
Hello, Does someone has got a sample config of a BRI for voice (H323 or MGCP) configuration at Austria ?I need to migrate a legacy pabx with voice bri to a cisco router.Much appreciatedDirk
Is there a way in Unity to set up message notification that will dial a users cell phone and tell them they have a new voice message and will also allow them to key in there user ID and password and check these new messages?Thanks,Chris
